User manual ZENITH ZN411

[. . . ] Match the batteries to the + and - marks inside the battery case, then insert 2 AAA Alkaline batteries. Press the battery cover back into place. Power-On Default The remote powers on in TV mode. TV Volume/Mute Punch-Through The TV Volume/Mute punch-through feature lets you control the Volume and Mute function of your TV in any mode programmed to be a VCR, Cable, or DVD device, without needing to change to TV mode. Battery Saver Your remote automatically times out if the buttons are depressed more than 30 seconds. This will save your batteries should your remote get stuck in a place where the buttons remain depressed (e. g. , between the sofa cushions). VCR Punch-Through Punch-through to VCR mode is only allowed in TV, and Cable modes. Code Setup The Code Search button is used to setup the remote. [. . . ] Note this action is also available by pressing any Mode key. TV/VCR Punch-Through VCR Punch-through is only available in TV, and Cable modes, i. e. the 6 VCR keys (Play, Pause, Stop, Record, FF and Rewind) will punch-through to the device programmed under VCR when in TV mode. The TV/VCR/INPUT button performs the TV/VCR antenna switch function when in VCR Mode. The TV/VCR/INPUT button performs the A. B switch function when in Cable Mode. The TV/VCR/INPUT button performs the INPUT source switch function when in TV Mode. The TV/VCR/INPUT button performs the DVD Setup function when in DVD Mode. Misc. CC will activate the Closed Caption feature if your device has that feature. TV/VCR and TV/DVD Combo units Note that for some TV/VCR and TV/DVD combo units you might need to set up two different buttons to control both parts of the combo unit. E. G. , (referring to the Direct Code Entry section on the following page) you might need to set up a code under the TV button to control the TV part of the combo unit AND a separate code for the VCR or DVD under any other button you choose. 8 9 Code Entry Direct Code Entry 1. Press and hold the Code Search button until the red indicator stays on. Note: If some buttons do not operate your equipment, try one of the other codes for your brand. Press the Channel Up button repeatedly (up to 300 times) until the device to be controlled changes channel. If you accidentally overshoot the code required, press the Channel Down button to backtrack through the library until the device changes channel. The above assumes that you want to store VCR codes under the VCR button, DVD codes under DVD, etc. If you want to store a VCR code under DVD, etc. , first follow the procedure on page 10 and try ANY DVD code from the code tables, e. g. Note: If the device does not have a Channel Up button, use Play (VCR only) or Power instead. Code Search starts from the currently stored three digit number under that mode e. g. if the mode has 100 codes and the currently stored code is 050 then the Code Search starts from 051 continuing to 100 before looping back to 000 and finishing at 050. This simplifies the process if you find that several preprogrammed codes operate your device by allowing you to bypass codes already tried. 1. 3. Write your codes down here for easy reference later. [. . . ] Defective product must be returned, with the dated proof of purchase, to the place of purchase for replacement. This warranty does not extend to the product if it has been damaged or rendered defective as a result of accident, misuse, abuse, tampering with or modification. THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. [. . . ]