User manual ZENITH FFH-185A OPERATING GUIDE

[. . . ] The CLASS 1 LASER PRODUCT label is located on the exterior. 2 IMPORTANT SAFETY INSTRUCTIONS 1. - All these safety and operating instructions should be read before the product is operated. - The safety, operating and use Instructions should be retained for future reference. - All warnings of the product and in the operating instructions should be adhered to. [. . . ] the "MUTE" indicator blinks on the display. MDSS(Multi Dynamic Sound System) Press the "MDSS" button to reinforce treble(Hi-Tone), bass(UBB: Ultra Bass Booster) and surround effect. To cancel it press the "MDSS" button again. Sound Quality Adjustment To activate stereo sound You can choose between 4 fixed sound impressions: select a desired sound mode by using the "EQ PATT. " button on the remote control. FLAT : linear frequency response ROCK : more bass, more treble POP : less bass, less treble CLASSIC : for orchestral music Headphone Socket. The speakers are automatically disconnected when you plug in the headphones (not supplied). AUXILIARY FUNCTION 1. NOTE: You can also record from the auxiliary input source, see Cassette Deck Function Section. 8 TUNER FUNCTIONS To listen to the Radio 1. Press the "TUNER/BAND" button repeatedly to choose either AM or FM radio. To tune to the desired station with automatic tuning, keep "TUNING (+)/(-) , ( )" button or depressed for more than 1 second. To tune to the desired station with manual tuning, press the "TUNING (+)/(-) , ( )" button within 1 or second repeatedly. When listening to FM stations press the "MODE/RIF" button for FM stereo reception. The "STEREO" will appear in the display. When a weak FM station is being received-press the "MODE/RIF" button so that "STEREO" is cleared from the display. NOTE: Use "MODE/RIF" (Radio Interference Filter) button to switch to mono reception if stereo reception is distorted by noise. Presetting the stations 1. To clear any programm previously stored in any memory. (1) Press the "PROG. /MEMO. " button for 2 seconds in TUNER mode so that "RESET" flashes in the display. (2) Press the " STOP/CLEAR" button while "RESET" is flashing in the display. To memorize the stations in order (1) Press the "TUNER/BAND" button to select a desired wave band. (2) Press the "TUNING (+)/(-) ( )" button to select a or desired station. (3) Press the "PROG. /MEMO. " button on the unit and preset number flashes. (4) Press the "PROG. /MEMO. " button again on the unit while preset number is flashing. (3)Select a desired channel number by pressing the "PRESET (+)/(-) or PRESET " button, while the preset number flashes. (4)Press the "PROG. /MEMO" button on the unit , while the preset number flashes. (3)Press the "PROG. /MEMO. " button again on the unit while the channel number is flashing. 5. To recall presets Press and hold the "PRESET (+)/(-) or PRESET " button until the desired preset number appears or press it repeatedly. 9 CD FUNCTIONS To play a CD 1. [. . . ] To cancel the TIMER, press the timer button so that " " in the display disappears. Set the minute to switch on by pressing the "PRESET (+)/(-)" buttons. The hour with "OFF" now flashes in the display. 12 SLEEP FUNCTION When the sleep timer is used, the power is automatically turned off after the specified time has elapsed. Each time the button is pressed the time interval before it tums off is reduced by 10 minutes. [. . . ]