User manual ZENITH DVB352 OPERATING GUIDE

[. . . ] Installation and Operating Guide | Warranty Model Number | DVB352 | DVD Player © Copyright 2003, Zenith Electronics Corporation Safety Precautions CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. FCC WARNING: This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. REGULATORY INFORMATION: FCC Part 15 This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] If you set a rating for the player, all disc scenes with the same rating or lower will be played. Higher rated scenes will not be played unless an alternative scene is available on the disc. You must enter the 4-digit password or change the rating level in order to play the disc. If you forget your 4-digit password If you forgot your password, to clear the current password, follow the procedure below. 2 Use the Number buttons to enter the 6-digit number "210499". The 4-digit password is cleared. "P CLr" appears on the display for a moment. 5 Press SELECT/ENTER to confirm your rating selection, then press SETUP to exit the menu. 3 Enter a new password as shown above to the left (Rating). 15 PRE-OPERATION Enter the code of a country/area whose standards were used to rate the DVD video disc, referring to the list (See "Country Code List", page 26. ). DVD Operation Playing a DVD Playback Setup DVD Exchanging discs during playback Press DISC EXCHANGE on the front panel during playback to open the disc tray. Exchange the discs and press DISC EXCHANGE or OPEN/CLOSE to close the disc tray. ote ­ The disc tray presently loaded in the play position can not be exchanged. Turn on the TV and select the video input source connected to the DVD player. Audio system: Turn on the audio system and select the input source connected to the DVD player. 1 chosen disc 2 Load yourside down. in the tray, with the playback Do not load a disc in the left or right side position. Center Position Tray Press OPEN/CLOSE to open the disc tray. Skipping discs Press DISC SKIP during playback or in Stop mode. otes ­ When DISC SKIP is pressed, the disc tray rotates and playback begins from the beginning of the next disc. ­ If there is no disc on the next disc tray, the following disc tray will be selected. ­ When DISC SKIP is pressed during playback of disc 5, playback of disc 1 will start. · Discs can be loaded one at-a-time. 3 Pressautomatically. onto closescreen, not start, READING appears the TV and playback starts If playback does press PLAY. In some cases, the disc menu might appear instead. Exchanging the disc and starting playback 1. Press OPEN/CLOSE during playback or in Stop mode. Play stops (if pressed during playback), the disc tray opens and the disc that was in the play position comes to the front. If a menu screen is displayed A menu screen may be displayed first after loading a DVD with menus. DVD 2. The tray closes and playback begins (with the disc that is in front). Use the 1 234 buttons to select the title/chapter you want to view, then press SELECT/ENTER to start playback. otes ­ If Parental Control is set and the disc is not within the Rating settings (not authorized), the 4-digit code must be entered and/or the disc must be authorized (see "Parental Control", on page 15). Your player will not play discs that have a Region Code different from your player. The region code for this player is 1 (one). 16 DVD Operation (Continued) General Features ote Unless stated otherwise, all operations described use the remote control. Some features may also be available on the Setup menu. Still Picture and Frame-by-Frame Playback DVD Changing TITLEs 1 /3 DVD Slow Motion DVD 1. Press SLOW t or T during playback. The DVD player will enter SLOW mode. When a disc has more than one title, you can move to another title as follows: Press DISPLAY then use the appropriate numbered button (0-9) to select a title number. 2. [. . . ] "Dolby", "Pro Logic", and the double-D symbol are trademarks of Dolby Laboratories. DTS and DTS Digital Out are registered trademarks of Digital Theater Systems, Inc. 27 REFERENCE ZENITH ELECTRONICS CORPORATION DVD PLAYER DVB352 LIMITED WARRANTY - USA Zenith will repair or replace your product, at Zenith's option, if it proves to be defective in material or workmanship under normal use, during the warranty period ("Warranty Period") listed below, effective from the date ("Date of Installation") of original installation of the product. This warranty is good only to the original purchaser of the product and effective only when used in the United States, excluding U. S. Territories. WARRANTY PERIOD: LABOR: 90 DAYS from the Date of Purchase. HOW SERVICE IS HANDLED: Call 1-877-993-6484 for instructions on getting the defective unit repaired or replaced. [. . . ]