User manual YAESU VP-1000

[. . . ] YAESU VP-1000 AC POWER SUPPLY FOR THE VL-1000 LINEAR AMPLIFIER The VP-1000 is an external AC power supply for use with the VL-1000 Linear Amplifier, providing 48 Volts DC at up to 48 amperes for extended periods. [. . . ] Turn the Circut Breaker on the VP-1000 rear panel ON, then turn the VP-1000 MAIN switch ON to activate the power supply. Always turn the VP-1000 Circut Breaker and MAIN switch on before turning on the VL-1000 POWER switch. To assure long life of the components, a primary consideration in setting up the VP-1000 is providing for adequate ventilation around the cabinet. The cooling system of the VP-1000 must be free to draw cool air in at the bottom of the chassis, and to expel warm air out of the rear panel. Avoid heating vents and window locations that could expose the VP-1000 to excessive direct sunlight, especially in hot climates. CIRCUIT DIAGRAM AC POWER CONNECTIONS The VP-1000 Power Supply does not require any transformer re-wiring, nor any changing of a switch position; the power supply will operate from either 230 or 120 Volt line voltages without configuration changes. However, the AC power cable/plug configuration will be somewhat different, depending on the country in which you purchased your power supply. In some countries, the VP-1000 is shipped with the standard 230 Volt connector appropriate for your location. In those areas where there are multiple 230 Volt connectors in common use, the VP-1000 is shipped without the power connector; one may be obtained at a local hardware or electrical supply store. [. . . ] version) USA PLUG UK PLUG European PLUG Australian PLUG (European version) (viewed from plug prong side) [. . . ]