User manual X10 SH624

[. . . ] Security/Home Automation Remote Model SH624 The Security/Home Automation Remote Control combines the features of security remotes with the features of Home Automation Remotes. It lets you arm and disarm the DS7000 or DC8700 Security System in HOME and AWAY modes. [. . . ] Note: If the remote did not register, remove the label on the front and use a pencil or other pointed object to press the small CODE button to generate a new random code. CODE button under label ARM HOME/ARM AWAY The Remote lets you arm the system with or without Motion Sensors being armed. Press ARM AWAY on the Remote Control to arm all Door/ Window Sensors AND Motion Sensors. Press ARM HOME on the Remote Control to arm ONLY Door/ Window Sensors. This lets you arm the system at night without accidentally tripping the system yourself when you move around your home. Sounding the PANIC Alarm Triggering the panic alarm trips the alarm but will not cause the system to dial out unless you arm the system first. Press DISARM to cancel the alarm. PANIC ARM HOME ARM AWAY PANIC DISARM DISARM Controlling X10 Modules Use the 4 ON-OFF buttons to control X10 Modules set to codes 1, 2, 3, and 4 and to the same Housecode as the Remote Control and your Security Console. Then press Bright or Dim to brighten/dim lights connected to Lamp Modules or Wall Switch Modules. SECURITY LIGHT ON OFF Replacing batteries Use four AAA alkaline batteries. After replacing batteries, the following steps are necessary to determine that the Console still recognizes the Remote Control. If the system arms, the Console recognized the Remote Control and no further action is necessary. If the system did not arm: Repeat "Installing the Remote" as described above. [. . . ] When set to MAX Motion Sensors will still trigger the alarm instantly, but Door/Window Sensors (that's you've set to MAX) will have a 1 minute exit and 30 sec. entry delay. See: http://www. x10. com/support/return_policy. htm for warranty info. X10. com, a Div. [. . . ]