User manual X10 KR21A

[. . . ] KR21A DigiPadTM Remote installation and operating instructions The KR21A works with the RR501 (part of the RC5000) and the TM751 (part of the RC6500). It lets you turn on and off four individually coded X-10 Modules and brighten and dim lights connected to Lamp Modules and Wall Switch Modules. [. . . ] If you do not follow this programming sequence, the LED will stay on for 1 second and your existing setting will not be changed. To change the Unit Code for the FIRST number button · The following procedure changes the code for the FIRST button, the other three follow on in sequence. if you set the first button to 5, the four buttons will control units 5, 6, 7, 8, etc. ). 3 seconds later, the LED blinks the current setting (for the FIRST button): 1 blink for Unit Code 1, 2 blinks for 2, 16 blinks for 16. · Press and release # 2 button the appropriate number of times for the Unit Code you want for the FIRST button. Note, if you set the first button to 16, then the buttons control 16, 1, 2, 3. To change the battery: Pry the unit apart and fit a CR2025 Lithium 3V battery. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. ANY CHANGES MADE TO THE UNITS WILL VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT. Press 1, 2, 3, or 4, first. Then press to turn ON. Note: You must press ON or OFF within 6 seconds after pressing a number button. X10 Wireless Technology, Inc. [. . . ] Please visit www. x10. com/warranty to complete your on-line warranty registration. For help or more information on setup, please visit: www. x10. com/support KR21A-9/01 [. . . ]