User manual WHIRLPOOL WRS325FDAT WARRANTY INFORMATION

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL WRS325FDAT. We hope that this WHIRLPOOL WRS325FDAT user guide will be useful to you.


WHIRLPOOL WRS325FDAT WARRANTY INFORMATION: Download the complete user guide (85 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL WRS325FDAT ENERGY GUIDE (403 ko)
   WHIRLPOOL WRS325FDAT DIMENSION GUIDE (88 ko)
   WHIRLPOOL WRS325FDAT USE & CARE GUIDE (1362 ko)
   WHIRLPOOL WRS325FDAT INSTALLATION GUIDE (793 ko)

Manual abstract: user guide WHIRLPOOL WRS325FDATWARRANTY INFORMATION

Detailed instructions for use are in the User's Guide.

[. . . ] 36 Parts Lists and Wiring Diagrams are located in the center of this manual, printed on yellow paper. November 1992 Page 1 WRS325FDAT FOR THE INSTALLER The WRS325FDAT is designed to fit the following Scotsman storage bins: · B90 and extensions, with bin top KBT18. · BH900 using bin top KBT24 (one unit) · BH900 with bin top KBT25 (two units side by side · BH550 or HTB500 using bin top KBT14. When installing a new system, check to be sure that you have everything you need before beginning: · Correct Bin · Correct Ice Machine · Correct Bin Top · All kits, legs, and information required for the specific job. Back View Allow 6" above machine for service. Liquid Line Connection Discharge Line Connection Remote Condenser Junction Box Electrical Inlet 20. 84" Water Inlet 3/8" Flare 3" 5. 25" 2. 96" Drain 3/4" FPT SPECIFICATIONS: ICE MAKER Model Number Dimensions (w/o bin) HXWXD 27" x 21" x 24" same Basic Electrical 208-230/60/1 208-230/60/3 Ice Type Cond. [. . . ] ///////////////////////////////////////////////////////////////////////// 7. Prepare the cleaning solution: Mix eight ounces of Scotsman Ice Machine Cleaner with three quarts of hot water. Slowly pour the cleaning solution into the water reservoir until it is full. As the ice maker begins to use water from the reservoir, continue to add more cleaning solution to maintain a full reservoir. After all of the cleaning solution has been added to the reservoir, and the reservoir is nearly empty, switch the master switch to OFF. After draining the reservoir, as in step 6, wash and rinse the water reservoir. Continue ice making for at least 15 minutes, to flush out any cleaning solution. Check ice for acid taste - continue ice making until ice tastes sweet. ///////////////////////////////WARNING///////////////////////// DO NOT USE any ice produced from the cleaning solution. ////////////////////////////////////////////////////////////////////////// 15. Add warm water to the ice storage bin and thoroughly wash and rinse all surfaces within the bin. Check that the fan blades are clean, and the fan secure to the fan motor shaft. Check the head pressure control valve, it should be maintaining a head pressure above 220 psig. If the unit has the correct charge, and the condenser is clean, and the refrigerant lines are not kinked or twisted, and the condenser is not overheated by external heat loads, the head pressure should be under the trip out point of the head pressure control switch. If all of the above are found to be good, and the machine trips out on high head pressure, replace the head pressure control valve. E. This switch will open if the bin control (ice level sensor) does not shut the machine off when the ice storage bin is full of ice: ice backs up in the ice chute, and internal pressure opens the switch, stopping the machine. If there is not enough water in the reservoir, the water level sensor will keep the machine from starting. a. If the machine does not start, see the next page. November 1992 Page 25 WRS325FDAT SERVICE DIAGNOSIS: Condition - No Ice Being Produced STATUS: NOTHING OPERATES G. Check: The gear motor, if it will not run, the compressor will not run. If no power to it: Check: the indicator lights on the circuit board, the bin empty light should be ON, the no water light should be OFF . If the bin empty and no water lights are off, check the transformer. a. If the line side has the correct voltage and the load side does not, replace the transformer. [. . . ] A) Remove the cap screws holding the gearmotor case halves together and pry the two cases apart. B) To lift off the cover, lift up until you can feel internal contact, then pull the cover towards the output gear end, and then lift the cover (with drive motor attached) up and away from the gear motor case. Note: The case cover output gear, bearings, and shaft are one pressed together assembly. If the oil level and condition is acceptable, quickly check the gears and bearings. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL WRS325FDAT




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL WRS325FDAT will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.