User manual WHIRLPOOL WDT995SAFM INSTALLATION GUIDE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL WDT995SAFM. We hope that this WHIRLPOOL WDT995SAFM user guide will be useful to you.


WHIRLPOOL WDT995SAFM INSTALLATION GUIDE: Download the complete user guide (26761 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL WDT995SAFM USE & CARE GUIDE (13121 ko)
   WHIRLPOOL WDT995SAFM USE & CARE GUIDE (13121 ko)
   WHIRLPOOL WDT995SAFM WARRANTY INFORMATION (185 ko)
   WHIRLPOOL WDT995SAFM WARRANTY INFORMATION (185 ko)
   WHIRLPOOL WDT995SAFM ENERGY GUIDE (374 ko)
   WHIRLPOOL WDT995SAFM DIMENSION GUIDE (380 ko)
   WHIRLPOOL WDT995SAFM USE & CARE GUIDE (13121 ko)
   WHIRLPOOL WDT995SAFM WARRANTY INFORMATION (185 ko)

Manual abstract: user guide WHIRLPOOL WDT995SAFMINSTALLATION GUIDE

Detailed instructions for use are in the User's Guide.

[. . . ] 13 2 DISHWASHER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING. [. . . ] Place the small (green) drain hose clamp onto the small end of the drain hose. Push the new drain hose into the rubber drain hose connector up to the drain hose stop. Slide clamp onto connector Drain hose Small clamp Rubber drain hose connector Stop Stop Drain hose stop Get /8" compression x /4" hose fitting with 90° elbow. See the “Tools and Parts” section at the front of the guide for part details and orders. Connect the 3/8" compression fitting of the 90° elbow fitting to the water supply line. attach such that the 3 /4" connection is facing upward as shown above. 3 3 Using pliers, squeeze open the small drain hose clamp and slide it onto the connector between stops. Install strain relief NOTE: Route drain hose out the rear of the dishwasher. POWER CORD CONNECTION NOTE: If removing a previous dishwasher with a power cord, you will need to transfer the power cord to the new dishwasher. See the “Tools and Parts” section at the front of the guide for part details and orders. Power cord – route cord into terminal box Use a 1/4" nut driver or 1/4" hex head socket wrench to remove the screw that holds the terminal box to the cross brace. Then, tilt the terminal box, free the tab, and lift the terminal box away from the crossbar. Route cord so that it does not touch dishwasher motor or lower part of dishwasher tub. NOTE: A maximum of 2 power cord supply conductors (12 AWG largest size) plus 1 grounding conductor are permitted in the terminal box. Remove cover Remove the cover by sliding it up and lifting its hooks out of the slot. Failure to follow these instructions can result in death, fire, or electrical shock. Power cord – connect ground wire Ground wire Tighten strain relief screws to secure cord. Power cord – reinstall terminal box cover and wires Ground screw Remove the ground connector screw on the raised floor inside the box and place it through the ring terminal of the green ground wire of power cord. Reattach and tighten the ground connector screw to the raised floor of the box. Power cord – connect remaining wires Place wires inside terminal box. Replace the cover by inserting the hooks of the terminal cover into the slots in the floor of the terminal box and sliding the cover tight against the back wall where wires come in. Make sure wires are tucked inside the box and not pinched by the cover. [. . . ] Reconnect power Reconnect electrical power at the fuse box or circuit breaker box. NOTE: With the access panel off, start the dishwasher and allow it to complete the shortest wash cycle. After the first 2 minutes, unlatch door, wait 5 seconds, then open door. 24 INSTALL ACCESS PANEL – For Plastic: Begin with Step 62 – For Metal: Begin with Step 65 Plastic Panel: Metal Panel: 65. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL WDT995SAFM




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL WDT995SAFM will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.