User manual WHIRLPOOL UXT4030ADB DIMENSION GUIDE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL UXT4030ADB. We hope that this WHIRLPOOL UXT4030ADB user guide will be useful to you.


WHIRLPOOL UXT4030ADB DIMENSION GUIDE: Download the complete user guide (180 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL UXT4030ADB USE & CARE GUIDE (2002 ko)
   WHIRLPOOL UXT4030ADB INSTALLATION GUIDE (2002 ko)
   WHIRLPOOL UXT4030ADB WARRANTY INFORMATION (94 ko)
   WHIRLPOOL UXT4030ADB USE & CARE GUIDE (2002 ko)
   WHIRLPOOL UXT4030ADB INSTALLATION GUIDE (2002 ko)
   WHIRLPOOL UXT4030ADB WARRANTY INFORMATION (94 ko)

Manual abstract: user guide WHIRLPOOL UXT4030ADBDIMENSION GUIDE

Detailed instructions for use are in the User's Guide.

[. . . ] All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING. € These words mean: DANGER WARNING You can be killed or seriously injured if you don't immediately follow instructions. You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. [. . . ] –  Always turn hood ON when cooking at high heat or when flambeing food (i. A copy of the above code standards can be obtained from: National Fire Protection Association 1 Batterymarch Park Quincy, MA 02169-7471 CSA International 8501 East Pleasant Valley Road Cleveland, OH 44131-5575 ■ A 120 volt, 60 Hz. 3 cm) Installation Clearances If the house has aluminum wiring, follow the procedure below: 1. Connect the aluminum wiring to the added section of copper wire using special connectors and/or tools designed and UL listed for joining copper to aluminum. follow the electrical connector manufacturer's recommended procedure. Aluminum/copper connection must conform with local codes and industry accepted wiring practices. C A D B ■ ■ Wire sizes and connections must conform with the rating of the appliance as specified on the model/serial rating plate. The model/serial plate is located behind the filter on the rear wall of the range hood. Wire sizes must conform to the requirements of the National Electrical Code, ANSI/NFPA 70 (latest edition), or CSA Standards C22. Venting Requirements These range hoods are factory set for non-vented (recirculating) installations and come with a charcoal filter. See the “Assistance or Service” section for information on ordering a charcoal filter kit, Part Number W10355450. Complete the Installation ■ Install a 120V, 75W maximum, incandescent light bulb with E12 base. See “Replacing the Incandescent Light Bulb” in the “Range Hood Care” section. See “Charcoal Grease Filter” in the “Range Hood Care” section. If the range hood does not operate, check to see whether a circuit breaker has tripped or a household fuse has blown. –  A B ■ C NOTE: To get the most efficient use from your new range hood, read the “Range Hood Use” section. 7 RANGE HOOD USE The range hood is designed to remove smoke, cooking vapors and odors from the cooktop area. For best results, start the hood before cooking and allow it to operate several minutes after the cooking is complete to clear all smoke and odors from the kitchen. On/Off light switch Operating the light B C Press the light switch to the left to turn the light On. RANGE HOOD CARE Cleaning IMPORTANT: Clean the hood and grease filters frequently according to the following instructions. Exterior Surfaces: IMPORTANT: Do not use soap-filled scouring pads, abrasive cleaners, cooktop polishing creme, steel wool, gritty washcloths or paper towels. To avoid damage to the stainless steel, do not use cleaners that contain chlorine. [. . . ] Replace the lens cover by squeezing the cover and inserting the tabs into the slots. Please have the following information available when you call the Customer eXperience Center: ■ Name, address and telephone number ■ Model number and serial number ■ A clear, detailed description of the problem ■ Proof of purchase including dealer or retailer name and address 1. Before contacting us to arrange service, please determine whether your product requires repair. Please take a few minutes to review the Troubleshooting or Problem Solver section of the Use and Care Guide, scan the QR code on the right to access additional resources, or visit www. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL UXT4030ADB




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL UXT4030ADB will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.