User manual WHIRLPOOL GSI 4048 WS INSTRUCTION FOR USE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL GSI 4048 WS. We hope that this WHIRLPOOL GSI 4048 WS user guide will be useful to you.


WHIRLPOOL GSI 4048 WS INSTRUCTION FOR USE: Download the complete user guide (247 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL GSI 4048 WS MODE D'EMPLOI (219 ko)
   WHIRLPOOL GSI 4048 WS KURZANLEITUNG (126 ko)
   WHIRLPOOL GSI 4048 WS CUADRO DE MANDOS (126 ko)
   WHIRLPOOL GSI 4048 WS SCHEDA PROGRAMMI (127 ko)
   WHIRLPOOL GSI 4048 WS GEBRUIKSAANWIJZING (212 ko)
   WHIRLPOOL GSI 4048 WS BEDIENUNGSANLEITUNG (214 ko)
   WHIRLPOOL GSI 4048 WS INSTRUZIONI PER L'USO (172 ko)
   WHIRLPOOL GSI 4048 WS TABLEAU DE PROGRAMMES (127 ko)
   WHIRLPOOL GSI 4048 WS LIBRO DE INSTRUCCIONES (219 ko)
   WHIRLPOOL GSI 4048 WS PRODUCT-INFORMATIEBLAD (127 ko)
   WHIRLPOOL GSI 4048 WS PROGRAM CHART (126 ko)
   WHIRLPOOL GSI 4048 WS SCHEDA PROGRAMMI (127 ko)

Manual abstract: user guide WHIRLPOOL GSI 4048 WSINSTRUCTION FOR USE

Detailed instructions for use are in the User's Guide.

[. . . ] • Before cleaning or carrying out maintenance, switch off the appliance, disconnect the mains plug and turn off the water tap. • If a fault occurs, switch off the appliance and turn off the water tap. • The open dishwasher door can only support the weight of the loaded rack when pull out. Do not rest objects on the open door or sit or stand on it since the appliance may topple over. [. . . ] The use of detergent in excess of the recommended dosage may cause pollution. For programmes with additional selected functions: “Half load”: load the upper or lower rack only. Use a smaller quantity of detergent. Normal load: For programmes with pre-rinse. (Example: Normal 65°C, refer to the “Wash programme chart”). For programmes without pre-rinse: • Pour the entire recommended dosage in the large compartment. If the recommended dosage on the detergent pack is over 45 ml, pour the remaining detergent in the small compartment. 16 94000-gb. fm5 Page 17 Thursday, September 13, 2001 4:13 PM HOW TO USE THE DISHWASHER Close the dishwasher door and turn on the water tap. 1. Once set, the programmed data cannot be altered by turning the programme selector knob or pressing the buttons. Note: Once the Start button has been pressed, the dishwasher memorises all the programmes selected. To change the programme selected, press the Start button for about 5 seconds until the Start indicator lamp switches off. Select a new programme using the programme button and press the Start. The End indicator lamp (if fitted) illuminates briefly and the Start indicator lamp switches off to indicate the end of the programme. Press the ON/OFF button to switch off the dishwasher (only after the End indicator lamp has switched on or the Start indicator lamp has switched off). Note: If the dishwasher is switched off during a wash programme, when switched on again the dishwasher resumes the wash cycle from where it was interrupted. Open the door and unload first the lower rack and then the upper one. 3 4 5/6 17 94000-gb. fm5 Page 18 Thursday, September 13, 2001 4:13 PM CONNECTIONS Refer to the separate installation instructions booklet. Water inlet and drain: • Strictly follow local Water Board regulations. • Make sure the inlet and drain hoses are kinkfree and are not crushed. • If the hose length does not suffice, replace with similar hoses obtained from your local dealer or our After-Sales Service. • The inlet hose must be securely clamped to the water tap to prevent leaks. [. . . ] When loading large items in particular, make sure the water circulates and does not collect inside them. The Start indicator lamp or indicator lamp F1. . . F9 flashes (depending on the model installed), if a fault is detected. F9 flashes (depending on the model installed), if a fault is detected. Other fault signals depending on the model installed: The indicator lamp on the control panel flashes to indicate that the water-stop system has tripped. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL GSI 4048 WS




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL GSI 4048 WS will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.