User manual WHIRLPOOL ETKT 9400/02/IN INSTRUCTION FOR USE

[. . . ] • Cut an opening in the worktop of the dimensions shown in the Product Description Sheet supplied separately. • If not already present, fit the supplied seal to the cooktop flange after cleaning the contact area as shown in the figure. • If the worktop is made of wood, use the supplied spring clips and screws. [. . . ] • Insert the supply cord in the strain release and connect the wires to the junction block following the indications given in the scheme printed on the cover. • After the electrical connection, fit the hob from the top and hook it to the support springs, according to the illustration. 11 1gb58913. fm Page 12 Friday, March 5, 2004 12:29 PM ENERGY SAVING TIPS • Use pots and pans whose bottom diameter is equal to that of the cooking zone or slightly larger. A pressure cooker allows you to save even more energy and time. . • • • • PROTECTING THE ENVIRONMENT 1. Packing • The packaging material can be100% recycled, as confirmed by the recycling symbol ( ). If you decide to scrap the appliances act responsibly and observe local waste disposal by laws. Cut off the power cords so that the appliances cannot be connected to the mains. • • • • • The appliances are designed, built and sold in compliance with: The safety requirements of “Low Voltage” Directive 73/23/EEC. This appliance complies with Class “Y” fire protection category. Declaration of conformity CE • These appliances are designed to come into contact with foodstuffs and they are constructed in compliance with Directive 89/109/EEC. for room heating) is considered as improper use and potentially dangerous. . • PRECAUTIONS AND GENERAL RECOMMENDATIONS • • • • Before any maintenance on the appliance disconnect it from the electrical power supply. The appliances must be repaired or adjusted exclusively by a qualified technician. Make sure that the electrical wires of other electrical appliances near the cooktop do not come into contact with hot parts. Do not switch on the hotplates/cooking zones when there is no pan in position. Use pans whose base diameter is the same as or slightly larger than the diameter of the hotplate/cooking zone. To avoid permanently damaging the glassceramic top, do not use: - Pots with bottoms that are not perfectly flat; - Metal pots with enamelled bottom. • • • Do not use the cooktop as a work surface or a support surface. If the glass ceramic surface should break or crack due to violent impact (falling objects, etc. . . ) do not use it and call After-Sales Service immediately. [. . . ] • The cooktop should be treated periodically with a proprietary brand of protective wax for glass-ceramic hobs. TROUBLESHOOTING GUIDE Cooktop not working • Ensure that the cooktop is receiving electrical power. Set the main disconnect switch upline of the appliance to “OFF” for a few minutes and then back to “ON” and see if the problem persists. 13 1gb58913. fm Page 14 Friday, March 5, 2004 12:29 PM AFTER SALES SERVICE Before contacting After Sales Service 1. Turn off the appliance and restart it to see if the fault is repeated. [. . . ]