User manual WHIRLPOOL AKM 260

[. . . ] · After use, ensure that the knobs are in position (off), and close the main gas delivery valve or the gas cylinder valve. · Warning: The protective rubber feet on the panstand grids represent a choking hazard for young children. After cleaning the panstand grids, please ensure that all the rubber feet are correctly fitted. Declaration of conformity · This cooktop has been designed, constructed and marketed in compliance with: - safety requirements of EEC Directive "Gas" 90/396; - safety requirements of EEC Directive "Low voltage" 73/23; - protection requirements of EEC Directive "EMC" 89/336; - requirements of EEC Directive 93/68. [. . . ] Check the "Troubleshooting guide" above to see if you can eliminate the trouble yourself. Re-start the cooktop, to check whether correct operation has been restored. Give the following information: · type of malfunction; · model of cooktop; · service number (i. e. , the number that follows the word SERVICE on the rating plate under the cooktop and on the guarantee paper); · your complete address; · your telephone number and area code. If any repairs are required, please contact an authorised After-Sales Service, as indicated in the warranty. In the unlikely event that an operation or repair is carried out by an unauthorised technician, always request a certification of the job carried out and insist on the use of original spare parts. Failure to comply with these instructions may compromise the safety and quality of the product. 16 3gb53231b. fm5 Page 17 Friday, April 11, 2003 12:21 PM INSTALLATION Technical information for the Installer This cooktop can be embedded in a worktop 20 to 50 mm thick. If there is no oven beneath the cooktop (any oven installed must be manufactured by us and equipped with a cooling system), insert a separator panel at a minimum distance of 20 mm from the bottom of the cooktop. Note: before installation, make sure that the local gas delivery conditions (nature and pressure of gas) are compatible with the settings of the cooktop, as indicated on the Product Description Sheet and on the rating plate. · If a vertical piece of furniture is installed, there must be a gap of at least 100 mm between it and the edge of the cooktop. · Before installation, remove the plastic film protecting the appliance, if provided. The outer surfaces of the furniture or appliances adjacent to the cooktop must be heat resistant (heat protection "Y") according to standards. · In the room where the cooktop is installed, there must be enough air to allow the gas to burn correctly (see the separate Product Description Sheet). · The natural flow of air must take place through an adequate opening, that must be: - permanent, made on one of the outside walls of the room, and communicating with the exterior in an area away from sources of pollution; - built so as to ensure that its openings, both on the inside and on the outside, cannot be obstructed, intentionally or accidentally; - protected by a metal grid or mesh that does not reduce its working section; - situated near the floor level and positioned so as not to interfere with the operation of the fume exhaust devices. - The fume exhaust has to take place through an appropriate hood or fan installed on the wall or on the window. Assembly · Apply the supplied gasket to the cooktop (if not yet fitted), after having cleaned its surface as shown in the relevant figure. [. . . ] Use pressure regulators suitable for the gas pressures indicated in the separate Product Description Sheet. The gas nozzles must be changed by After Sales Service or a qualified technician. Nozzles not supplied with the appliance must be ordered from After Sales Service. [. . . ]