User manual WHIRLPOOL ACM 710

[. . . ] Disposal of packaging materials: dispose of the various packing materials responsibly, in full compliance with local authority regulations governing waste disposal. This induction hob is designed solely for use as a domestic appliance. The appliance is not intended for use by people (children included) with physical, sensory or mental impairment or without experience and knowledge of the appliance, unless supervised or previously instructed in its use by those responsible for their safety. The cooking zones become extremely hot during use: keep children away from the appliance to avoid the risk of scalding or burns. [. . . ] To guarantee correct operation, the appliance must be installed on a perfectly flat surface. If necessary, cut the kitchen unit and worktop to fit before installing the hob. Clean the cutout of any chips that could compromise appliance operation. 77x35 770 350 52 325 min. 8 490 +2 0 +2 0 275 380 510 330 +1 0 +2 0 750 Domino 380 51 484 342 min. 8 +2 0 +2 0 490 350 Dimensions in mm To guarantee correct operation, the appliance must be installed on a perfectly flat surface. If necessary, cut the kitchen unit and worktop to fit before installing the hob. Clean the cutout of any remaining dust that could compromise appliance operation. For the distance between the underside of the induction hob and the kitchen unit (or separating panel), observe the dimensions given in the figure at the side. If a column unit is installed adjacent to the hob, leave a distance of at least 100 mm from the edge of the hob. min. Fit the brackets (C) in the centre of the vertical sides, aligning the upper edge of the brackets so that they are flush with the worktop surface (fig. Fix the brackets with the 4 screws supplied (B) using the holes provided. Insert the hob in the cutout, making sure the clips (A) are secured in the spaces provided (fig. 2 13 31902052GB. fm Page 14 Wednesday, September 3, 2008 4:05 PM A fig. 4 Undercounter oven installation: · If an oven (which must be of our manufacture) is to be installed under the hob, ensure it is equipped with a cooling system and observe the distances given in the figure to the side. · There must be nothing between the cooktop and the oven (cross rails, panels, brackets, etc. ). 5 mm OPERATING INSTRUCTIONS Control panel Timer On/Off Child lock the symbols are not active!To select the desired functions, touch the areas below. Cooking zone controls and corresponding display Control panel graphics shown in these instructions might not match exactly the graphics of your hob. Button's functions are the same for all hob models. Switching the hob ON/OFF To switch the hob on, press the button for approx. If the hob has been in use, the residual heat indicator "H" remains lit until the cooking zones have cooled down. The hob automatically switches off if no function is selected within 10 seconds of switching on. 14 31902052GB. fm Page 15 Wednesday, September 3, 2008 4:05 PM Switching on and adjusting cooking zones Heat setting indicator Button Cooking zone positioning Button + Selected cooking zone indicator After switching on the hob and positioning the pot on the chosen cooking zone, adjust the heat setting using the button +. Each cooking zone has different heat settings that can be adjusted using the buttons +/-, which go from "1": min. [. . . ] · Make sure you place the pot or pan in the centre of the cooking zone outlined on the hob. · The symbol on the appliance, or on documentation enclosed with the appliance, indicates that this product must not be treated as household waste, but must be delivered to the nearest collection centre for the recycling of electrical and electronic appliances. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For further information on the treatment, recovery and recycling of this appliance, contact your competent local authority, the collection service for household waste. Declaration of Conformity · This hob is suitable for contact with foodstuffs and complies with EEC (CE) regulation n. [. . . ]