User manual WHIRLPOOL 63851341

[. . . ] - Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this appliance. - Installation and service must be performed by a qualified installer, service agency or the gas supplier. - Install a separanting panel under the appliance - Use appliance in well ventilated rooms only. The electrical and gas connections must comply with local regulations. [. . . ] · Keep children away from the hob when it is in use and do not let them play with the controls or any other appliance parts. SAVE THESE INSTRUCTIONS 5019 619 01340 ELECTRICAL CONNECTION Installation must be carried out by a qualified electrician who is fully aware of current safety and installation regulations. The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the regulations provided in this chapter. GAS CONNECTION · The gas supply system must comply with local regulations. · You can find specific local regulations for some countries in the paragraph "Reference to Local Regulations". If no information concerning your country is given, please ask details to your installer. · The connection of the hob to the gas pipe network or gas cylinder must be made by means of a rigid copper or steel pipe with fittings complying with local regulations, or by means of a continuous-surface stainless steel hose complyingwith local regulations. · Before connecting the tube to the elbow fitting (A), interpose the washer (B) supplied, in compliance with EN 549. NOTE: if a stainless steel hose is used, it must be installed so as not to touch any mobile part of the furniture. It must pass through an area where there are no obstructions and where it is possible to inspect it on all its length. · After connection to the gas supply, checkfor leaks with soapy water. Electrical connections · Hob electrical connection must be made before connecting the appliance to the electricity supply. · Electrical connection must be carried out in compliance with the regulations of the local electric utility company. · Make sure that the voltage indicated on the rating plate on the underside of the appliance corresponds to the domestic power supply voltage. If a column unit is installed adjacent to the hob, leave a distance of at least 100 mm from the edge of the hob. UNDERCOUNTER OVEN INSTALLATION: · If an oven (which must be of our manufacture) is to be installed under the hob, ensure it is equipped with a cooling system and observe the distances given in the figure to the side. · There must be nothing between the cooktop and the oven (cross rails, panels, brackets, etc. ). MAINTENANCE Care and maintenance Clean the hob after each use in order to avoid damaging the surface and to prevent the formation of baked-on deposits which are difficult to remove. Before cleaning, make sure the cooking zones are switched off and that the residual heat indicator ("H") is not displayed. 5 mm · Disconnect power before servicing · DO NOT clean the hob with a steam cleaner NOTE: Periodically check for dust under the appliance, near the cooling air inlet or the outlet openings. This could hinder the ventilation and cooling of the electronic module and decrease the effectiveness of the hob. ADJUSTMENT TO DIFFERENT TYPES OF GAS This operation must be performed by a qualified technician. If a different type of gas to that specified on the dataplate and on the orange sticker on the back of the hob is used, the injectors must be replaced. Use pressure regulators suitable for the gas pressure indicated in the Product Description Sheet. · The injectors must be changed by the After-Sales Service or a qualified technician. · Nozzles not supplied with the appliance must be ordered from After Sales Service. Note: when liquid petroleum gas is used (G30/G31), the minimum gas setting screw must be tightened as far as it will go. Should you experience difficulty in turning the burners knobs, please contact the After Sales Service for the replacement of the burner tap if found to be faulty. To clean the hob, proceed as follows: 1. use a soft clean cloth, absorbent kitchen wipes or a proprietary cleaner for glass ceramic hobs. [. . . ] By ensuring that this appliance is scrapped suitably, you can help prevent potentially damaging consequences for the environment and health. · The symbol on the appliance, or on documentation enclosed with the appliance, indicates that this product must not be treated as household waste, but must be delivered to the nearest collection centre for the recycling of electrical and electronic appliances. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For further information on the treatment, recovery and recycling of this appliance, contact your competent local authority, the collection service for household waste. Electrical Appliances. After-sales Service Before contacting After-sales Service: · Try to solve the problem (see "Troubleshooting guide (induction zone)"). [. . . ]