User manual VISIONEER VRS3 INSTALLATION GUIDE

[. . . ] VirtualReScan® 3. 5 Installation Guide 10300408-000 Revision A Copyright Copyright © 2004 Kofax Image Products. The information contained in this document is the property of Kofax Image Products. Neither receipt nor possession hereof confers or transfers any right to reproduce or disclose any part of the contents hereof, without the prior written consent of Kofax Image Products. No patent liability is assumed, however, with respect to the use of the information contained herein. [. . . ] 5 The VRS installation analyzes your system for the amount of space available on the default drive and lists the Space Required and Space Available values below the destination folder information. Accept the default installation folder, C:\PROGRAM FILES\KOFAX\IMGCTLS, or click Browse to select another destination. The default destination may vary if 16 VRS Installation Guide Installation you previously installed VRS or another Kofax application to another location. Figure 2-8. VirtualReScan Setup ­ Confirm Destination Folder Screen 6 If there is not enough disk space to continue the installation, you will be notified via a message box: There is not enough space to install the option(s). Please free up some disk space or modify your selections. In this situation, click OK to clear the message. Then click Cancel and Exit Setup from the subsequent screens to quit the VRS installation. ­or­ When installing to a drive other than C:, you can verify disk space on the other drive before proceeding. To check the disk space on an alternate drive: a Click the Disk Space button. b At the screen similar to Figure 2-9, select a drive from the list and click OK. The values for available and required space will be updated on this screen and on the VirtualReScan setup page. c Click OK to return to the installation. VRS Installation Guide 17 Chapter 2 Figure 2-9. Disk Space Settings 7 Click Next to confirm the installation folder. VirtualReScan Setup ­ Select Scanner 8 Do one of the following: · Select your scanner from the list and click Next. · Select the option to configure the scanner later if you plan to download a VRS Component Installer for a VRS-certified scanner that does not appear on the list, and then click Next. · Select the option to configure the scanner later if you have a non-certified VRS scanner that does not appear on the list. When using a non-certified scanner, you will need to use the Kofax Source Manager from the Windows Control Panel to configure the scanner to work with 18 VRS Installation Guide Installation VRS. For more information, refer to Configuring Non-Certified Scanners on page 31. Note If you are using a Böwe Bell & Howell 8000 B/C scanner, two versions of the scanner will appear on the scanner pick list. "Böwe Bell & Howell 8000 B/C" corresponds to the standard interactive version. "Böwe Bell & Howell 8000 B/C (non-interactive mode)" is the appropriate selection if you want to run VRS in the background. When non-interactive mode is in effect, you cannot see or use VRS dialog boxes while documents are being scanned. See Appendix D, VRS Non-Interactive Mode on page 41 for more information. [. . . ] Once you have installed the scanner using these instructions, you will be able to use the VRS RDV utility to switch between another scanner to this one and vice versa. 40 VRS Installation Guide Appendix D VRS Non-Interactive Mode Non-Interactive Mode vs. Interactive Mode Users of the Böwe Bell & Howell 8000 B/C scanner have the choice of selecting VRS in a non-interactive mode at the time of installation. This mode is specifically designed for Böwe Bell & Howell users who do not wish to see any VRS dialog boxes while scanning, yet would like VRS to run conveniently in the background. While this feature is automatically set during installation of the Böwe Bell & Howell 8000 B/C scanner, VRS non-interactive mode can be switched back to interactive mode. [. . . ]