User manual US ROBOTICS USR2450 REFERENCE GUIDE

[. . . ] Wireless Access Point Windows 95, 98, 2000, Me, NT, and XP Companion Reference Guide R24. 0258. 00 Step 1. Connect the Wireless Access Point · Use the Ethernet port and an RJ-45 cable to connect the Wireless Access Point to one of the following devices: a cable or DSL modem with routing capabilities, a hub, a bridge, an existing Ethernet LAN, or a router. Attach the power supply to the Wireless Access Point. Step Two: Install your software Note: You only need to install this software on the PC or laptop that was originally connected to your modem, bridge, router, or hub. Insert your U. S. In the Choose Setup Language window, select your preferred language and click OK. Note: If your CD-ROM does not automatically launch, click Windows Start, Run, and type D:\setup (or the appropriate letter of your CD-ROM drive) and click OK. Some files will be copied to your system, and then you will be asked to read the license agreement. [. . . ] There is also the Change Password option, where you can change your password. It is recommended that you write down the password for future reference. If you forget your password, you will be locked out of the Access Point Web Configurator. You can reset the Wireless Access Point to restore the default settings. While holding in the Reset button, unplug the power adapter from the Wireless Access point and then plug it back in. If you press the Reset button a second time, all setting information except for the password and the encryption data will be cleared. When you are finished changing your password, click Apply for the new password to be activated. For security purposes, it is recommended that you change your password after you successfully log in. Anytime you reset the Wireless Access Point, your password will revert to the default setting. When you are finished viewing or changing your Wireless Access Point information, click Logout. Click Yes. Troubleshooting My computer does not recognize the Wireless Access Point after I changed the settings. Possible Solution: Ensure that the WLAN Configuration utility is installed for your Wireless Access Point and that the Configuration utility is installed and functioning for your Wireless Access PC Cards or PCI Adapters. Possible Solution: Ensure that you are contacting the correct Wireless Access Point and using the correct MAC address. Possible Solution: Ensure that the correct password and encryption option are being used. If you changed the settings in the configuration of the Wireless Access Point, you must also change the settings of every Wireless Access PC Card or PCI Adapter attached to this network. The settings of the Wireless Access PC Cards or PCI Adapters must match the new settings of the Wireless Access Point. Possible Solution: Be sure that each Wireless PC Card or PCI Adapter that you want to connect to the wireless network is set to Infrastructure mode within the Configuration Utility. If your Wireless Access PC Cards or PCI Adapters are not set to Infrastructure mode, they will not be able to communicate with the Wireless Access Point. While holding in the Reset button, unplug the power adapter from the Wireless Access point and then plug it back in. If you press the Reset button a second time, all setting information except for the password and the encryption data will be cleared. Possible Solution: Your Wireless Access Point may not have received a valid IP address for your network. If you see a window stating that a free IP address could not be determined when you double-click the Wireless Access Point in the Access Point Configuration Utility, you need to manually assign an IP address. [. . . ] Robotics' option and expense, to refund the purchase price paid by Customer for any defective software product, or to replace any defective media with software which substantially conforms to applicable U. S. Customer assumes responsibility for the selection of the appropriate applications program and associated reference materials. Robotics makes no warranty or representation that its software products will meet Customer's requirements or work in combination with any hardware or applications software products provided by third parties, that the operation of the software products will be uninterrupted or error free, or that all defects in the software products will be corrected. Robotics software product documentation or specifications as being compatible, U. S. [. . . ]