User manual THEBEN ELPA 8 SCHEMA

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual THEBEN ELPA 8. We hope that this THEBEN ELPA 8 user guide will be useful to you.


THEBEN ELPA 8 SCHEMA: Download the complete user guide (82 Ko)

You may also download the following manuals related to this product:

   THEBEN ELPA 8 FICHE TECHNIQUE (485 ko)

Manual abstract: user guide THEBEN ELPA 8SCHEMA

Detailed instructions for use are in the User's Guide.

[. . . ] do not adjust System Channel to "A" position and Unit Channel to "1" position on all Theben series. Though Theben series provide 256 combinations for channel settings, the best for the user is to use 255 combinations and exclude one combination A1 from your channel setting because A1 is very easy to get interference from other similar product in the market that eventually makes wirefree device abnormal working. Loosen the screws of unit's front case with a screwdriver and open the front case (See Fig. [. . . ] Loosen the screws of unit's front case with a screwdriver and open the front case (See Fig. If it is necessary, adjust the channel dials to the proper position with a screwdriver (See Fig. Note: System channel (or house channel) and unit channel have each 16 sets coding that provide flexible combination capability a total of 256 (16x16) different combinations. â· Make sure the arrowheads are adjusted to the proper positions. â· Make sure the transmitter and receiver are set with the same channels i. Adjusting two units' system channel (house channel) to position "I" and the unit channel to position "9". In order to obtain the best transmission and reception performance, suggest to install Receiver ELPA 8 at least one meter high from floor since ground is the best wave absorber. The LED of Receiver ELPA 8 turns on and the control unit of Receiver ELPA 8 starts to work upon receiving ON signal from any combining transmitter. The LED of Receiver ELPA 8 turns off and the control unit of Receiver ELPA 8 stop working upon receiving OFF signal from any combining transmitter. The working time of the control unit of Receiver ELPA 8 depends on the time setting of transmitter (LU 102-180 HF only). When Receiver ELPA 8 fails to work normally, check assumptive problems and suggested solutions in following table that will hopefully solve your problem. Make sure the combining transmitter and receiver ELPA 8 are set with same channel. Make sure there is no other radio waves affecting the transmission and reception of transmitter and receiver ELPA 8. Make sure the combining transmitter and receiver ELPA 8 are in effective working range. [. . . ] Make sure there is no other radio waves affecting the transmission and reception of transmitter and receiver ELPA 8. Make sure the combining transmitter and receiver ELPA 8 are in effective working range. Make sure the combining transmitter and receiver ELPA 8 are in effective working range. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE THEBEN ELPA 8




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual THEBEN ELPA 8 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.