User manual SONY ICD-SX46

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SONY ICD-SX46. We hope that this SONY ICD-SX46 user guide will be useful to you.


SONY ICD-SX46 : Download the complete user guide (660 Ko)

You may also download the following manuals related to this product:

   SONY ICD-SX46 (614 ko)
   SONY ICD-SX46 (616 ko)
   SONY ICD-SX46 (617 ko)
   SONY ICD-SX46 (903 ko)
   SONY ICD-SX46 (772 ko)
   SONY ICD-SX46 (772 ko)
   SONY ICD-SX46 (772 ko)
   SONY ICD-SX46 (615 ko)
   SONY ICD-SX46 (635 ko)
   SONY ICD-SX46 (697 ko)
   SONY ICD-SX46 (756 ko)
   SONY ICD-SX46 (2085 ko)
   SONY ICD-SX46 annexe 2 (618 ko)
   SONY ICD-SX46 annexe 1 (664 ko)
   SONY ICD-SX46 annexe 1 (618 ko)
   SONY ICD-SX46 INSTRUCTION/OPERATION MANUAL (780 ko)
   SONY ICD-SX46 INSTRUCTION/OPERATION MANUAL (779 ko)
   SONY ICD-SX46 (772 ko)
   SONY ICD-SX46 annexe 2 (211 ko)
   SONY ICD-SX46 annexe 3 (665 ko)
   SONY ICD-SX46 annexe 1 (665 ko)
   SONY ICD-SX46 DATASHEET (412 ko)

Manual abstract: user guide SONY ICD-SX46

Detailed instructions for use are in the User's Guide.

[. . . ] BGetting started IC Recorder Operating Instructions Owner's Record The model number is located at the rear and the serial number is located inside the battery compartment. Refer to these numbers whenever you call upon your Sony dealer regarding this product. Serial No. Step 1: Installing the Batteries 1 Slide and lift the battery compartment lid. Notes · Do not use manganese batteries for this unit. · When you replace the batteries, insert the new ones within 3 minutes after you remove the exhausted ones. [. . . ] You can set the OPR indicator to turn off even in operation. BOther Information Specifications Recording media Built-in flash memory 128 MB (ICD-SX46) / 256 MB (ICD-SX56) / 512 MB (ICD-SX66), Stereo/Monaural recording Recording time See "Recording Messages". Frequency range · ST: 60 Hz - 13, 500 Hz · STLP: 60 Hz - 6, 900 Hz · SP: 60 Hz - 7, 000 Hz · LP: 80 Hz - 3, 500 Hz Speaker Approx. Power output 150 mW Input/Output · Microphone jack (minijack, stereo) ­ input for plug in power, minimum input level: 0. 6 mV, 3 kilohms or lower impedance microphone · Headphones jack (minijack, stereo) ­ output for 8 - 300 ohms headphones · USB connector · DC IN 3V jack (For Korean and the People's Republic of China models, this jack does not exist. ) Playback speed control +100% to ­50% (DPC) Power requirements Two LR03 (size AAA) alkaline batteries: 3 V DC Dimensions (w/h/d) (not incl. projecting parts and controls) 28. 0 × 120. 0 × 13. 8 mm (1 1/8 × 4 3/4 × 9/16 in. ) Mass (incl. batteries) 64 g (2. 26 oz) Supplied accessories Stereo headphones × 1 USB connecting cable × 1 Application Software (CD-ROM) × 1 LR03 (size AAA) alkaline batteries x 2 Carrying pouch x 1 Optional accessories Stereo headphones MDR-EX71SL, MDRE931LP/Active speaker SRS-T88, SRS-T80/ Electret condenser microphone ECM-CS10, ECM-TL1, ECM-DS70* (* for Tourist model only)/Audio connecting cable RK-G134HG, RK-G135HG, RK-G136HG, RK-G139HG (excluding Europe)/AC power adaptor ACE30HG (excluding the models for Korea, the People's Republic of China, Australia, and New Zealand) Your dealer may not handle some of the above listed optional accessories. Design and specifications are subject to change without notice. Precautions On power · Operate the unit only on 3 V DC. On safety · Do not operate the unit while driving, cycling or operating any motorized vehicle. On handling · Do not leave the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. · Should any solid object or liquid fall into the unit, remove the batteries and have the unit checked by qualified personnel before operating it any further. On noise · Noise may be heard when the unit is placed near an AC power source, a fluorescent lamp or a mobile phone during recording or playback. · Noise may be recorded when an object, such as your finger, etc. , rubs or scratches the unit during recording. On maintenance · To clean the exterior, use a soft cloth slightly moistened in water. If you place a magnetic card near the speaker of the unit, the card may be affected by the magnet of the speaker and may become unusable. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. 1 Playing back a message rapidly or slowly Slide the DPC switch to "ON". "FAST" or "SLOW" flashes for 3 seconds and the message is played back at the speed specified with the menu. Note When you want to play back an MP3 file of more than 192kbps, set the DPC switch to "OFF", or if the switch is set to "ON", adjust the speed of the playback to slower than 10% (toward ­). If the speed is set to faster than 10% (toward +), "NO FAST" will appear and the playback becomes normal. 2 Turn the jog lever toward MENU. The menu mode will be displayed. Adding Priority Mark(s) in the Stop Mode 2 3 While "ALL ERASE" is flashing, press ERASE. All the recorded messages contained in the folder are deleted. The folder itself will not be deleted. 1 2 Select the message you want to mark. Press A-B (repeat)/ PRIORITY for more than 1 second. "" and the message number indication will flash on the display window. Press the jog lever up or down (>/. ) to select "LED on". Press the jog lever (x·B). The LED setting mode will be displayed. 3 Adding a Recording to a Previously Recorded Message When REC-OP in the menu is set to "ADD", you can add a recording to the message being played back (see "Using an Adding Recording"). The added recording will be placed after the current message and counted as a part of the message. During playback of Message 3 After adding a recording 4 Message 3 Message 4 Setting the playback speed You can set the playback speed when the DPC switch is set to "ON". The setting for the playback speed holds effective until you change the setting. 3 Message 3 Message 4 Added recording 1 1 During playback, press zREC/REC PAUSE briefly. "REC" and "ADD" will flash and the unit stops in the recording pause mode. Turn the jog lever toward MENU to display the menu mode. [. . . ] To stop A-B Repeat playback Press xSTOP. Play back the message you want to move. Turn the jog lever toward FOLDER repeatedly to select the folder that you want to move the message into. The destination folder and "MOVE" flash. The first and last 5 seconds of the message will be played back. Erasing Messages one by one You can erase unnecessary messages only. When a message is erased, the remaining messages will advance and be renumbered so that there will be no space between messages. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE SONY ICD-SX46




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SONY ICD-SX46 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.