User manual SOLAC CP7385

[. . . ] Remove all elements from the inside or outside of the appliance used for protection during transport or for sales promotions, such as paper or plastic bags, plastic sheets, cardboard and stickers. Switch off the appliance when not in use, even if only for a moment. Do not use it with damaged or broken guide combs, or when blade teeth are missing. [. . . ] For optimum battery life use the appliance until the battery is completely run down and then recharge it fully. The first time you use the device do it slowly and carefully until you acquire a perfect working knowledge on the functioning of the device. Follow this advice, especially when shaving sensitive areas of the body, since the skin also needs to adapt to the shaving process. If this is not the case, cut the hair to a short length with the cutting blades (2) or (3). During use, the shaving head must be in permanent contact with the skin. Slide the shaver in the direction opposite to the direction in which hair grows, with a soft pressure. Recommendations: Pull your skin when moving the shaver on top of it and let the shaver move smoothly with the exact pressure. The first time you use the appliance, cut a small amount of hair until you get used to the length of each position. We recommend that you begin with the maximum cutting length position (6 mm) and, in the event of wanting a shorter cut, change to lower positions (4 or 2 mm). Place the guide comb (4) on the head, attaching it to the two side sections Fig. Cut the hair by moving the appliance in the opposite direction to that in which the hair grows. To cut the hair EVENLY, let the clipper ADVANCE SMOOTHLY through the hair. Before trimming, check that the appliance is clean and that there are no traces of hair between the blades, as this could prevent it from working properly. For this purpose, after removing the comb, clean the blade (2/3) with the attached brush (12). [. . . ] All repairs and battery replacements should be carried out by an Authorized Service Shop. When you want to dispose of the appliance, NEVER throw it in the rubbish bin. Take it to your nearest RECYCLING POINT or the waste collection centre closest to your home for processing. [. . . ]