User manual SILVERCREST SSMS 600 B3

[. . . ] Disconnect the hand blender from the mains power socket if you notice any faulty operation and before beginning to clean it. Should liquids enter the housing, disconnect the appliance from the mains power socket immediately and arrange for it to be repaired by a qualified technician. To unplug the appliance, always pull the plug from the socket, do not pull on the power cable itself. Do not crease or crimp the power cable and place it in such a way as to prevent anyone from stepping on or tripping over it. [. . . ] Only insert the plug into the power socket after you have assembled the appliance for use. NOTICE Before the first use, clean all parts as described in the chapter "Cleaning". Place the hand blender 5 on the motor unit 4 so that the arrow points to the symbol . Points to the symbol Assembling the wire whisk Insert the whisk 0 into the whisk holder 9. Place the so assembled whisk 0 onto the motor block 4 so that the arrow points to the symbol symbol . Turn the motor block 4 until the arrow points at the Assembling the liquidiser WARNING!SSMS 600 B3 7 GB IE Place the bowl lid 6 onto the bowl 8 and turn it until tight. Thereby, the lugs on the edge of the bowl 8 must be guided into the rail on the bowl lid 6. Place the motor unit 4 on the bowl lid 6 so that the arrow points to the symbol NOTICE Should you wish to keep foodstuffs in the bowl 8 you can remove the base of the bowl 8 and use it as a lid. For this, carefully remove the bowl lid 6 and motor unit 4 and, if needs be, the blade 7. Holding the appliance To operate the appliance, hold it as follows: 8 SSMS 600 B3 Operation WARNING!NOTICE When you beat cream with the whisk 0 hold the container at a slant during the beating. Ensure that cream cannot be sprayed out of the container while it is being beaten. When whipping cream, slide the speed regulator 1 to position "5". When you have assembled the blender set as you wish to use it: 1) Insert the plug into a mains power socket. 2) Press and hold the switch 2 to process foodstuffs at the standard speed. Slide the speed regulator 1 in the direction of "5" to increase the speed. Slide the speed regulator 1 in the direction of "1" to reduce the speed. 3) Press and hold the turbo-switch 3 to process foodstuffs at a higher speed. By pressing the turbo-switch 3 the maximum processing speed is available immediately. 4) When you have completed the processing of the foodstuffs, simply release the switch. NOTICE Should unusual noises be heard during operation, such as squeaks or similar, lubricate the drive shaft of the blender with a few drops of neutral cooking oil: GB IE SSMS 600 B3 9 GB IE Examples for the chopping and liquiding of various foods with the liquidiser: Ingredients max. [. . . ] GB IE SSMS 600 B3 15 GB IE Sweet Fruit Spread Ingredients 250 g Strawberries or other fruit (fresh or frozen) 1 packet (about 125 g) Preserving sugar without cooking 1 dash of Lemon juice 1 pinch of the pulp of a Vanilla pod Preparation 1) Wash and clean the strawberries, at the same time removing the green stems. Drain well in a colander, so that you are rid of excess water and the spread is not too watery. 5) Add the contents of the packet of preserving sugar without cooking and mix thoroughly with a hand blender 5 for 45-60 seconds. If there are still large pieces in it, allow it to stand for 1 minute and then purée it again for 60 seconds. [. . . ]