User manual SIEMENS WD7225

[. . . ] Further information and a selection of our products can be found on our Internet pa ge: http://www. siemens international. com Please read these operating and installa tion instructions and all other information enclosed with the washing machine and act accordingly. These operating and installation instruc tions describe various models which are distinguished by their selectable spin speeds. Retain all documentation for subsequent use or for the next owner of the appliance. Information concerning waste disposal Disposal of packaging Your new appliance was delivered to you in protective packaging. Please help by disposing of packa ging in an environmentally friendly manner. [. . . ] Following each change you can q change another standard setting or q return to the programme page by pressing the Back" and Cancel" buttons. q Set the time as described under Setting the time"; see from Page 10. Time Signal The acoustic signal signals the start and end of the programme, operating faults and malfunctions. You can specify the volume of the acou stic signal or switch off the acoustic si gnal. q Press the Extras" button. q Press the Settings" button. 30 q Adjust the volume of the signal by pressing the - signal" or signal +" button, e. g. i The - signal" button reduces the volume of the signal or switches the signal off (Signal: 0----), the Signal +" button switches the signal on or increases the volume (maximum volume: Signal: ---4"). q Press the Cancel" button. Childproof lock / Appliance lock You can safeguard your washing machine to prevent any unintentional changes to the selected functions and to the pro gramme sequence. An active childproof lock / appliance lock has the following effects: - If the appliance is switched off and then on again, a running programme continues at the point at which tt was interrupted. - The washing machine door remains locked when the wash cycle is com plete. - When the appliance has been swit ched on and the washing machine door closed, all operating elements are disabled and the washing machine door is locked. Activate the childproof lock / appliance lock q Press the Extras" button. q Activate the childproof lock / appliance lock by pressing the Childproof lock +" button. i When the childproof lock / appliance lock has been activated, the $" symbol is indicated on the display panel after the programme has started. 31 Temporarily deactivate childproof lock / appliance lock q Press and hold down the start/stop" button (4 seconds) until the start/stop" illuminated ring flashes. The programme summary contains the following information: - Selected programme, washing tempe rature and selected additional options. - Rinse sensor (not for Rinse", Spin" and Drain" programmes). i Leaf through the pages of the programme summary by pressing the More" and Back" buttons. 36 Removing the washing q Open the washing machine door. i Always switch off the washing machine, otherwise the load sensor will not detect the amount of laundry in the next wash programme. coins, paper clips) from the drum and rubber seal - risk of corrosion!i Leave the washing machine door open to allow the interior of the washing machine to dry. 37 No final spin" preselected? Display panel: Continue programme with Spin Drain" q Press the Spin" button. When the Spin" or Drain" programme has ended, Remove washing" is indica ted on the display panel; proceed further as described. 38 Childproof lock: ON" preselected? The start/stop" illuminated ring goes out. q Remove the washing. 39 Saving your favourite programmes Programmes which you use frequently with changed settings can be saved under the Memory1", Memory2" and Memory3" memory locations. Your saved favourite programme can then be selected by pressing the respective button. The end of the programme is not saved. q Select memory location, e. g. q Press the Select programme here" button until the desired programme is indicated on the display panel. [. . . ] Water inlet hose Warning Operate the washing machine with cold drinking water only. Do not connect to the mixer tap of an unpressurised hot water apparatus. The water inlet hose must not be - kinked or crushed, - modified or severed (strength is no lon ger guaranteed). Check the mains water pressure: - The water pressure should be bet ween 1 and 10 bars (when the tap is turned on, at least 8 litres of water is discharged per minute). [. . . ]