User manual SIEMENS GIGASET C470

[. . . ] s Issued by Gigaset Communications GmbH Schlavenhorst 66, D-46395 Bocholt Gigaset Communications GmbH is a trademark licensee of Siemens AG Gigaset Communications GmbH 2008 All rights reserved. www. gigaset. com Gigaset C470 Gigaset The handset at a glance The handset at a glance 17 16 INT 1 V 1 2 15. 11. 07 INT 09:45 SMS 3 4 5 15 14 13 12 11 10 9 8 6 7 The base station at a glance 1 Display (screen) in idle status 2 Charge status of the batteries = e V U (flat to full) = flashes: batteries almost flat e V U flashes: batteries charging 3 Display keys (page 10) 4 Message key Access to calls and message lists; Flashes: new message or new call 5 End call key, On/Off key End call, cancel function, go back one menu level (press briefly), back to idle status (press and hold), activate/deactivate handset (press and hold in idle status) 6 Hash key Keypad lock on/off (press and hold in idle status); Toggle between upper/lower case and digits (press and hold) 7 Call-by-call list key Open call-by-call list 8 Microphone 9 Recall key - Confer (flash) - Insert a dialling pause (press and hold) 10 Star key Ringer tones on/off (press and hold); With an open connection: switch between dial pulsing/touch tone dialling (press briefly); Open special characters table 11 Connection socket for headset 12 Key 1 Dial network mailbox (press and hold) 13 Talk key Answer a call, open last number redial list (press briefly), start dialling (press and hold); When writing an SMS: send SMS 14 Handsfree key Switch between earpiece and handsfree mode; Lights up: handsfree activated Flashes: incoming call 15 Control key (page 10) 16 Eco mode activated (page 12) 17 Signal strength i (high to low) | flashes: no reception Registration/paging key (page 33) 1 Contents Contents The handset at a glance . 32 32 33 33 34 34 34 35 36 37 37 37 37 38 38 38 39 40 40 ECO DECT . 55 3 Safety precautions Safety precautions Warning: Read the safety precautions and the user guide before use. [. . . ] They are shown in the SMS list and can, if necessary, be displayed by pressing the message key f. Deactivating a mailbox Yes if necessary. Set On/Off: to Off. Confirm message with All SMS messages saved in this mailbox will be deleted. Please note: u If you operate a number of devices (base stations) with SMS functionality on a single phone line, then each SMS mailbox ID may only occur once. In this case you must also change the preset ID of the general mailbox ("0"). u You can only use personal mailboxes if your service provider supports this function. You can tell whether this is the case by the addition of a star (*) to the number of a (preset) SMS centre. u If you have forgotten your mailbox PIN, you can reset it by restoring the base station's default settings. This will delete all SMS messages from all mailboxes. Set Protection: to Off. The mailbox PIN is reset to "0000". v Settings SMS Mailboxes s (select mailbox) Edit Press the display key. v Settings SMS Mailboxes s (select mailbox) ~ Enter mailbox PIN if necessary and press OK. Set ID:, Protection: and PIN (page 27). Deactivating PIN protection Changing the name of a mailbox Changing a mailbox's PIN and ID Setting up and changing a personal mailbox v Settings SMS Mailboxes s Select mailbox, e. g. Save changes (page 49). Setting up a personal mailbox Sending an SMS to a personal mailbox To send an SMS to a personal mailbox, the sender must know your ID and enter it after your number. Your SMS contact will receive your SMS number with current ID and can save it in his or her directory. If the ID is invalid, the SMS will not be delivered. 27 SMS (text messages) Setting SMS centres Entering/changing SMS centres SMS info services You can have your service provider send you specific information by SMS (e. g. You can obtain information about the SMS services available and their costs from your service provider. and special functions offered by your service provider before you make a new application and/or before you delete pre-configured call numbers. Change multiple line input: Active Send: Select Yes if SMS messages are to be sent via the SMS centre. Enter the number of the SMS service and insert a star if your service provider supports personal mailboxes. Save changes (page 49). You should find out about the services Setting up/ordering an SMS service v SMS Service s Select SMS service. Send Press the display key. Ordering an SMS service Setting up an SMS service hand if necessary. Save Press the display key. Edit Select an empty entry, delete before- Editing the entry of an SMS service Then: Please note: Ask your service provider for details on how to enter service numbers if you wish to use personal mailboxes (precondition: your service provider supports this function). Select the SMS service (see above). Options Sending an SMS through another SMS centre Edit Entry ~ Save Activate the SMS centre (2 to 4) as the Send the SMS. active send service centre. Open menu. Press the display key. Deleting an SMS service Then: Select the SMS service (see above). Options Open menu. Select and press OK. Delete Entry 28 SMS (text messages) SMS on a PABX Calling Line Identification is forwarded to the extension of the PABX (CLIP). The CLIP evaluation of the phone number for the SMS centre takes place in your Gigaset. [. . . ] 500 Standby time (hours) Talktime (hours) Operating time for 1. 5 hrs of calls per day (hours) 180 9 80 700 300 12 115 900 320 16 150 1100 395 19 180 Specifications Recommended batteries Technology: Nickel-metal-hydride (NiMH) Size: AAA (Micro, HR03) Voltage: 1. 2 V Capacity: 6001200 mAh We recommend the following battery types, because these are the only ones that guarantee the specified operating times, full functionality and long service life: u Sanyo Twicell 650 u Sanyo Twicell 700 u Panasonic 700 mAh "for DECT" u GP 700mAh u Yuasa AAA Phone 700 u Varta Phone Power AAA 700mAh u GP 850 mAh u Sanyo NiMH 800 u Yuasa AAA 800 The device is supplied with two recommended batteries. Charging time, base station (hours) Charging time, charging cradle (hours) 4 5 7 8 5 7 9 11 At the time of going to print, batteries up to 900 mAh were available and had been tested in the system. Due to the constant progression in battery development, the list of recommended batteries in the FAQ section of the Gigaset Customer Care pages is regularly updated: www. gigaset. com/customercare Base station power consumption In standby mode: approx. 1 watt 47 Notes on the user guide General specifications DECT standard GAP standard No. of channels Radio frequency range Duplex method Channel grid Bit rate Modulation Language code Transmission power Range Base station power supply is supported is supported 60 duplex channels 18801900 MHz Time multiplex, 10 ms frame length 1728 kHz 1152 kbit/s GFSK 32 kbit/s 10 mW, average power per channel up to 300 m outdoors, up to 50 m indoors 230 V ~/50 Hz v Display With the handset in idle status, press on the right of the control key (v) to open the main menu. [. . . ]