User manual SIEMENS GIGASET WLAN REPEATER 108

[. . . ] You can also connect a computer to the Internet via a DSL or cable modem with Ethernet interface in this Operating Mode. Ethernet adapter The Gigaset WLAN Repeater 108 can be connected directly to the Ethernet port of a computer or to a games console. There is no need to install any additional driver software on the computer or the games console. When you make a connection from a computer or games console to a wireless router, you operate the Gigaset WLAN Repeater 108 in the Ethernet adapter operating mode. [. . . ] Of the network connection with which you are connected to the Gigaset WLAN Repeater 108. ì In the Network window, select from the Configuration tab the TCP/IP entry for your network card or adapter. Make sure you choose the right one if there are several entries in the selection list (e. Click on the IP address tab and select the option Obtain IP address automatically. ì Check that the Power LED on the front panel of the unit is on continuously. You have now configured and opened a link between your PC and the Gigaset WLAN Repeater 108. In order to use the Gigaset WLAN Repeater 108, you must make some further configuration settings depending on the mode. For the initial configuration we suggest that you connect the Gigaset WLAN Repeater 108 with an Ethernet cable to the Ethernet port of the PC on which you wish to make the configuration. Please remember: If you want to use the Gigaset WLAN Repeater 108 in Operating Mode Ethernet adapter, please read the information on page 20 first. Delete any address that may already appear on the ì On the address line, enter the address 192. If you see the error message "This page cannot be displayed" instead of this screen, please check that you have typed the address correctly, make sure that your browser is not in offline mode and deactivate any other LAN connections of your computer. After a few moments you will see the start screen of the configuration programme. The basic settings wizard will take you through the configuration procedure step by step. It is strongly recommended that you carry out the security settings after completing the basic settings. Operating Mode Repeater After configuring the basic and security settings for Operating Mode Repeater, you must activate the WDS function on the access point. the operating instructions for the device will tell you how to do this. Configuration is complete once your Gigaset WLAN Repeater 108 has successfully connected to the access point. Remember, however, that the Gigaset WLAN Repeater 108 automatically assigns IP addresses to connected devices. You may have to alter the configuration if you have configured your Gigaset wireless router differently from its factory default settings. Further information about this will be found in the detailed operating instructions. You should restart all the devices once all the configuration settings have been made. Operating Mode Access point Once you have configured the basic and security settings for Operating Mode Access point, connect all the PCs, you wish to include in your wireless network to the Gigaset WLAN Repeater 108 by setting the correct SSID and the appropriate WEP encryption for your network adapters on it. [. . . ] This crossed-out wheeled bin symbol on the product means the product is covered by the European Directive 2002/96/EC. The correct disposal and separate collection of your old appliance will help prevent potential negative consequences for the environment and human health. it is a precondition for reuse and recycling of used electrical and electronic equipment. For more detailed information about disposal of your old appliance, please contact your city office, waste disposal service or the shop where you purchased the product. [. . . ]