User manual SIEMENS GIGASET SE551 DSL/CABLE

[. . . ] U one Gigaset SE551 WLAN dsl/cable, u one mains adapter (220 V / 12V 1A DC), u one cable with RJ-45 jacks (CAT5), u one CD with full user guide and driver software for operating a network printer on To operate your Gigaset SE551 WLAN dsl/cable you need: In order to be able to use the superior range and increased data throughput gained by using Super G technology, we recommend using a Gigaset PC Card 108 or a Gigaset USB Adapter 108. 0 for configuring your Gigaset SE551 WLAN dsl/cable, u for Internet access: ­ a DSL connection (splitter) or phone line, ­ a DSL or cable modem, ­ your Internet service provider's access data. First install the Ethernet network card or a wireless network adapter such as the Gigaset PC USB Adapter 108 in your PC. The installation procedure can be found in the products' user guide. [. . . ] ì In the Network window on the Configuration tab, select the TCP/IP option for your ì ì ì ì ì Make sure you select the right TCP/IP entry if there are several in the selection list. Click on the IP address tab and select the option Obtain IP address automatically. click on the Gateway tab and remove any entries in the Installed gateways list. ­ Restart your Gigaset SE551 WLAN dsl/cable by unplugging the power lead and plugging it in again. You have now configured and opened a link between your PC and the Gigaset SE551 WLAN dsl/cable. You now need to make a few configuration settings so that you can use your Gigaset SE551 WLAN dsl/cable to operate a local network and establish a connection to the Internet. The Gigaset SE551 WLAN dsl/cable provides you with a user interface which you can open with a web browser. Now carry out the following steps: ì Enter the IP address of the Gigaset SE551 WLAN dsl/cable in the browser's address 1 A Web page appears for you to enter a password. Please remember: For security reasons you should change the password at a later stage (refer to the user guide on the CD supplied). You can make the settings for the clock to change automatically to summer time and/or to the time zone as you wish. ì Select your Internet service provider and enter in the fields the access data that you Have received from your Internet service provider. ì Select the way your Internet connections are to be established: ­ Select Always on if the connection is to exist at all times when the Gigaset SE551 WLAN dsl/cable is switched on. Select Connect on demand if applications such as a web browser or an e-mail program are to connect to the Internet automatically. ­ In the Idle time before disconnect field, enter a period of time after which the Internet connection is to be automatically ended if no data is transmitted (default setting: 3 minutes). This means that the connection will continue to exist even if no data is transmitted. Select Connect manually if you always want to establish and end the connection to the Internet manually. If you have a time-based tariff this will save you high connection charges. In the next step the basic settings you have made are shown for you to check. ì If you want to make changes to the settings, click on Back. ì If you want to confirm the settings, click on Finish to close the basic setup wizard. [. . . ] In France, this device is only intended for internal use within buildings. We, Gigaset Communications GmbH, declare that this device meets the essential requirements and other relevant regulations laid down in Directive 1999/5/EC. A copy of the 1999/5/EC Declaration of Conformity is available at this Internet address: www. ì Aktivoi General/Yleiset-välilehdellä vaihtoehdot Obtain an IP address automatically/Hae IP-osoite automaattisesti ja Obtain DNS server address automatically/Hae DNS-palvelimen osoite automaattisesti. [. . . ]