User manual SHOPRIDER SFB-18

[. . . ] Check all electrical connections and mechanical parts are securely locked and fastened before using your E-Bike, and check all cables, connector plugs and sockets must be dry and undamaged. The E-Bike is not recommended for competition, stunt, any aggressive or off-road riding. The performance and mileage of the unit will be varied with the battery condition, temperature, terrain, wind speed, tire pressure, rider weight and the maintenance, etc. The E-Bike is able to sense your feet's force on the pedal to provide you the assist power once you ride it. [. . . ] The battery case will be locked and can't be removed when the key is in the vertical position. 2008/4/30 8 Battery and Charging Steps to charge the Battery 1. Dismount the battery case and then place it at a ventilated place to be charging. Swivel the charging port cover of battery case and then connect the charger plug of the charger. Plug the power plug of the charger into secure power source to start charging battery. Note: Ensure that the charger plug is dry and securely connected to the charger port of battery case. Must assure the battery to be charged is a LiFePO4 (Lithium Iron Phosphate Based) Battery Pack supplied by PMMC. Make sure the power cord, battery cable, and battery terminals are in good condition. Make sure the connecting battery rating is the same as the charger output voltage (24V). When the light turns GREEN, the battery is fully charged. Charger LED Indication 1. LED (GREEN) ­ Fully Charged, when connected to the batteries. Trouble Shooting 1. If the LED light is "OFF" all the time while charging: Check if the power connections are in good condition. If the LED light is still off all the time while charging, the battery charger may be malfunctioning. If the LED light does not switch from GREEN to RED when the charging process begins: Check if the connection of the battery polarity is correct. Check if the connection between charger plug and charging port of the battery is correct. The charging time continues for a long duration (Irregular): Check if the battery is out of order or aged. The battery overheats: 2008/4/30 9 Check the battery specification or consult your authorized dealer. Stop charging immediately and check if there is a problem with the charger or the batteries. Caution 1. Make sure the DC output connected to the battery to be charged is at the rated voltage, or it may cause unexpected danger or damage. For your safety, do not charge the batteries for longer than 24 hours. Do not expose the charger to the rain, water or a humid place; Do not use the battery charger near flammable articles or in unventilated places. For your safety, do not short circuit output plug, or it may cause unexpected danger or damage. Use the specified charger only for LiFePO4 (Lithium Iron Phosphate Based) Battery Pack (24V) supplied by PMMC. [. . . ] PMMC reserves the right to revise the wording and specification of the E-Bike without prior notice. 2008/4/30 17 APT Power Assist Folding Electric Bicycle R DISCLAIMER Congratulations on your purchase of SUNRUNNER® APT® Power Assist Folding Electric Bicycle. This APT® Power Assist Folding Electric Bicycle is not intended to be used by individuals with physical limitations that could prevent the user from operating the APT® Power Assist Folding Electric Bicycle safely. PMMC disclaims all responsibility for any personal injury or property damage, which may occur as a result of improper or unsafe use of its products. Mechanical or electrical defects will be dealt with on a contingency liability basis. [. . . ]