User manual SEGA CASH CUBE

[. . . ] INTRODUCTION TO THIS SERVICE MANUAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . INSTALLATION AND MAINTENANCE INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . HANDLING AND INSTALLATION PRECAUTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . NAME OF PARTS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 1 840-0137D-02 DESCRIPTION ASSY CASE NAT CKT PUB EXP 26 3. 10. MONITOR ADJUSTMENT The monitor adjustment pcb is located behind the logo plate on the opposite side to the coin entry bezel. Rotate retaining bracket to free Logo Plate. To gain access to the pcb: 1. Open the control panel after removing the two M6 security screws and using the Control Panel key (see section 3. 7. 1). Loosen the retaining bracket held on with 1 M4 screw to the lower right of the Logo Plate. This allows the bracket to rotate enabling the Logo Plate to be removed. 3. The Monitor Adjustment pcb is located directly behind this plate. 27 Note: Problems with the monitor that cannot be corrected by simple adjustment using the pcb are beyond the scope of this manual. 4 Michaelson Square Kirkton Campus Livingston Scotland UK EH54 7DP www. pentranic. com 28 3. 11. TROUBLESHOOTING · Only QUALIFIED SERVICE PERSONNEL should carry out these procedures. If a problem occurs, first check the wiring connections. PROBLEMS When the main switch is turned ON, the machine is not activated CAUSE The power is not ON. COUNTERMEASURES Firmly insert the plug into the outlet. Incorrect power source/voltage. AC Unit CIRCUIT PROTECTION DEVICE (i. e. ; fuse) was activated due to an instantaneous overcurrent. Make sure that the power supply/voltage are correct. First, remove the cause of overcurrent and reinstate the circuit protection device to its original status. Connect the cable to the motor assembly, ensuring that the 4-pin connector is the correct way round. Lower the motor assembly into the base, ensuring that the coin exit is in the rear exit position. Locate the lugs, on the front of the bowl, into the slots at the front of the base. Gently press down until the securing clips, on the base, click into the slots in the bowl. Routine cleaning: All accessible parts of the coin route should be cleaned periodically using a mild detergent on a damp cloth. Particular attention should be paid to the opto sensor at the coin exit to remove any build up of dirt. 31 3. 13. COIN MECHANISMS The machine uses a Coin Controls SR5 Coin Mechanism. 3. 13. 1. COIN MECHANISM OPERATION (FOR UK MACHINES). COINS ACCEPTED: 5P, 10P, 20P, 50P, £1, £2 COIN ROUTING The coin mech automatically routes all coins other than £1 coins to the cash box (exit C). £1 coins are routed to the hopper (exit A) until the float is achieved, afterwards they are diverted to the cash box (exit B). The float is maintained by software counting the number of £1 coins entered. The coin mech exits are as follows: A Hopper B Cash Box C Cash Box D Not Used. SR5 ­ COIN CONTROL ROUTING PLUG: 18 WAY Pt No PUB-64101UK 5-7, 8-15, 1à13, 10à13, 12à13, 16à13, 17à13, 18à13 The diode direction is shown as `à'. Note: Cash Payout - £1 Hopper only fitted. 3. 13. 2. COIN MECHANISM FAULT FINDING There is a green diagnostic LED used to provide a visual indication of the mechanisms current operation and error condition. LED ON = Power ON LED OFF = Power OFF LED will flash OFF once when Coins or Tokens are accepted or if reject Lever is pressed. [. . . ] After changing the settings, select EXIT and press the TEST Button to return to the Game Test Menu screen. 8. 2. 7. BOOKKEEPING SCREEN Select BOOKKEEPING to display the following screen and view up-to-date operational game data. There are four total BOOKKEEPING screens when CURRENCY is set to a monetary currency, such as POUND, and nine total screens when set to TOKEN. 70 8. 2. 7. 1. BOOKKEEPING FOR POUND, DOLLAR, EURO, OR ANY CASH SETTINGS BOOKKEEPING 1/4 Screen -------------------------------------------BOOKKEEPING 1/4 NUMBER OF GAMES PLAY TIME AVERAGE PLAY TIME LONGEST PLAY TIME SHORTEST PLAY TIME 0 0D 0H 0M 0S 0H 0M 0S 0H 0M 0S 0H 0M 0S PRESS TEST BUTTON TO CONTINUE -------------------------------------------NUMBER OF GAMES: PLAY TIME: AVERAGE PLAY TIME: LONGEST PLAY TIME: SHORTEST PLAY TIME: Total number of games played. Shortest of all games played. Pressing the TEST Button will bring up the following screen. BOOKKEEPING 2/4 Screen -------------------------------------------BOOKKEEPING 2/4 TIME HISTOGRAM 0M00S - 0M29S 0 0M30S - 0M59S 0 1M00S - 1M29S 0 1M30S - 1M59S 0 2M00S - 2M29S 0 2M30S - 2M59S 0 3M00S - 3M29S 0 3M30S - 3M59S 0 4M00S - 4M29S 0 4M30S - 4M59S 0 OVER 5M00S 0 PRESS TEST BUTTON TO CONTINUE -------------------------------------------PLAY TIME HISTOGRAM shows the number of plays and the respective play times. [. . . ]