User manual SANYO LNS-W01Z LENS REPLACEMENT AND INSTALLATION PROCEDURES
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SANYO LNS-W01Z. We hope that this SANYO LNS-W01Z user guide will be useful to you.
Manual abstract: user guide SANYO LNS-W01ZLENS REPLACEMENT AND INSTALLATION PROCEDURES
Detailed instructions for use are in the User's Guide.
[. . . ] LNS-W01Z / LNS-T01Z
LENS REPLACEMENT AND INSTALLATION PROCEDURES
NOTES ON REPLACEMENT AND INSTALLATION
The procedures and the needed pars for lens installation depend on the type of cabinet. Before installing or replacing the lens, make sure the type of cabinet and be sure to refer to the Installation Manual corresponding with your projector. [. . . ] · LIGHT-BLOCK SHEET 1 pc.
BE SURE TO CHECK FOR SAFETY
After installing or replacing the lens, be sure to check the following for safety. Check no wiring is tangled on the gear of lens motor or the other mechanical parts. Check no part is missing, or no mounting part is loose.
Some parts are not used for installation or replacement. Note : Figures in this manual may be differ from the actual product.
LENS REPLACEMENT AND INSTALLATION PROCEDURE
Perform the steps 1 to 5 for lens replacement and installation.
UPPER LENS COVER
C
1
REMOVE THE LENS COVER. Pull down the lower lens cover while pushing the part D, then remove it. D B
2
IN CASE OF MODEL WITHOUT LENS A
D
Fig-1
LOWER LENS COVER
REMOVE THE COVER PLATE OF THE LENS COVER. (At the step 4 , insert the light-block sheet in the same position as the removed cover plate has been placed. Two screws are not used. )
Set the light-block sheet, so that the large rounder side is set over the lens.
SCREWS COVER PLATE
Fig-2
IN CASE OF MODEL WITH LENS REMOVE THE LENS. Remove screws D (4 screws) which fastens the lens and remove the lens.
Figure shown inside of the cabinet. (D) (D)
LENS MOTOR
A
(D)
(D)
B A LENS MOTOR LEAD CONNECTOR " K16B"
Fig-3
3
INSTALL THE LENS. [. . . ] See figure-2. ) If the installation of light-block sheet is incorrect, it will be the cause of leakage of light or the dust entering at the main cabinet. Insert the upper part lens cover and fix them with screws A (4 screws). [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SANYO LNS-W01Z
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SANYO LNS-W01Z will begin.