User manual SANGEAN DT-400W

[. . . ] Insure and ship the unit via UPS, FedEx, or Parcel Post to: Sangean America, Inc. Service Department 2651 Troy Avenue South El Monte, CA 91733 2 3 1 Headphone/Antenna Jack The earphone also acts as the FM antenna when plugged into the earphone jack. While listening via speaker, you may plug the supplied wire antenna into the earphone jack, and set the ST/MO/SP. Volume Control DBB-Deep Bass Boost Switch on the DBB switch on the back top of the radio to activate the Deep Bass Boost to have stronger bass sound, display will appear DBB symbol. [. . . ] Place 2 `AA' batteries inside the unit oriented to the illustration located just below the battery compartment. NOTE: A flashing "E" appearing on the LCD display indicates a weak battery and that replacement of batteries is required. And the Weather Alert will be deactivated. Tuning the Radio Seek Tuning Turn radio on using the On/Off button located on the top of the radio. Select desired band by pressing the "Band" selector on the front of the unit. Press and hold the proper tuning button (Up/Down) for approximately ½ second. Repeat as many times as desired. 9 Manual Step Tuning Turn radio on using the On/Off button located on the top of the radio. Select desired band by pressing the "Band" selector on the front of the unit. Press the desired tuning button (Up/Down) repeatedly until desired frequency is found. See Setting Memory Section for instructions on how to program stations into radio memory. Turn radio on using the On/Off button located on the top of the radio. Press "My Favorites" button located on the right side of the radio. "MY" should appear on the right hand of the display indicating function is on. Use tuning controls (Up/Down) to navigate through memory programmed stations. Press "My Favorites" button to turn off memory tuning. 10 Setting Memory Turn radio on using the On/Off button located on the top of the radio. Select desired band by pressing the "Band" selector on the front of the unit. Tune to desired station using either Manual Step Tuning or Scan Tuning options. Press Memory Button located on the front of radio unit and use the tuning controls (Up/Down) to reach memory position as indicated in the top-right of the display. Press Memory Button located on the front of the unit to lock station into memory. [. . . ] Select hour by using the Tuning Control Buttons located just to the right of the display. Using the Tuning Control Buttons located just to the right of the display. Once time displayed matches desired setting press MEMO or CLOCK button once more. Time should display solidly, with the colon blinking periodically. 13 Change AM (MW) band tuning step In Europe and other parts of the world, AM (MW) tuning step are 9 kHz, in America the AM tuning step is 10 kHz. [. . . ]