User manual RUSSELL HOBBS 14582
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual RUSSELL HOBBS 14582. We hope that this RUSSELL HOBBS 14582 user guide will be useful to you.
Manual abstract: user guide RUSSELL HOBBS 14582
Detailed instructions for use are in the User's Guide.
[. . . ] 6 Don't run the motor continuously for more than 3 minutes, to avoid overheating. 7 Keep the appliance and the cable away from hotplates, hobs or burners. 8 Don't try to sit the mixer on it's end it'll fall over. [. . . ] 17 If the motor starts to labour, add more liquid to the mix, if possible, or switch off and carry on by hand. 18 If you need to set the mixer down, switch off (0), and shake any mixture off the attachment. 19 Don't run the motor continuously for more than 3 minutes, to avoid overheating. 20 Don't try to sit the mixer on it's end it'll fall over.
timings and speeds
21 Timing and speed will vary with the amount, thickness, and composition of the mix. Switch on, switch off, look/feel/taste, till it feels right.
care and maintenance
25 Switch off (0) before cleaning. 27 Wipe the handle with a damp cloth don't let liquid get inside the mixer. 33 Don't use harsh or abrasive cleaning agents or solvents.
charging
34 The battery loses its charge slowly when it's not in use. 37 Don't leave the adapter permanently connected you'll reduce the battery life. 39 Use the mixer only with the adapter supplied, and vice versa.
4
wall mounting
We cannot accept responsibility for any damage or loss of any nature arising out of this operation. If you're in any doubt about your ability to do this, employ a craftsman to do it for you. You'll need: a) 2 dome-head screws the underside of the heads must be flat, not countersunk, and the heads should be small enough to pass through the bottom of the "keyhole" shaped screw holes b) 2 wall plugs these must fit the screws c) a drill and bit to fit the screws or wall plugs d) a screwdriver to fit the screws
what to do:
1 Choose a location: close to a power socket, out of reach of children, and safe from the risk of accidental knocks. 5 Turn page 2 through 90 degrees, so that the edge of the page is horizontal. 6 Hold the page against the wall, and push a pin through the crosses to mark the wall. 8 Insert the wall plugs (if necessary), and push them in till they're flush with the wall surface. 9 Push the screws through the holes on the back of the mount, and into the holes or wall plugs. 11 Put the wall mount over the screws, so that the screw heads come through the bottom of the "keyhole" shaped screw holes. [. . . ] If it's not working, read the instructions, check that it's fully charged. If that doesn't solve the problem: Pack carefully, with a note of your name, address, day phone number, and what's wrong. If under guarantee, say where and when purchased, and include proof of purchase (till receipt). [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE RUSSELL HOBBS 14582
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual RUSSELL HOBBS 14582 will begin.