User manual ROWENTA DX6600

[. . . ] · In normal use a draggy coating may build up on the soleplate (starch, detergent build-up, burnt synthetic fibers). This can be easily removed by using the Rowenta Soleplate Kit or a quality hot iron soleplate cleaner available at most stores. The Rowenta kit is also available through our website: www. rowentausa. com · To prevent scratching of the soleplate, do not iron over sharp objects (zippers, etc. ). metal iron support, which may scratch the soleplate. Spray function does not work. Priming may be necessary on first use. 110 389 7423 If troubleshooting does not assist, before consulting the retailer regarding their return/exchange policy, please telephone consumer service at 781-396-0600. Rowenta Werke GmbH, 63016 Offenbach am Main SE CLE LF AN · Fill the iron with tap water to the max mark on the water tank. [. . . ] The Anti-drip function is active. POWER DUO 1 2 3 10 9 Iron is emitting a brown or white substance. Water may need to be changed due to hardness or organic matter. 11 12 DX6000_USA 18. 11. 2003 11:29 Uhr Seite 2 IMPORTANT SAFETY INSTRUCTIONS When using this appliance, basic safety precautions should always be followed including the following: Read all instructions before using this product. · To protect against a risk of electric shock, do not immerse the appliance in water or other liquids. · The appliance should always be turned off before plugging or unplugging from outlet. Never yank the cord to disconnect from outlet, instead grasp plug and pull to disconnect. · Always disconnect appliance from electrical outlet when filling with water or emptying when not in use. · Do not operate appliance with a damaged cord or if appliance has been dropped or damaged. · To avoid the risk of electric shock, do not disassemble the appliance. Ship it to the nearest authorized Rowenta approved service center for examination and repair. Incorrect reassembly can cause a risk of electric shock when the appliance is used. Close supervision is necessary for any appliance being used near children. Do not leave appliance unattended while plugged in, on an ironing board, or while it is still hot. · Burns can occur from touching hot metal parts, hot water or steam. · Do not direct steam at people, animals or iron clothes while they are being worn. · The use of accessory attachments is not recommended by Rowenta and may result in fire, electric shock or personal injury. Before use · Remove soleplate cover before using iron. · Please read all of the Instructions for Use and the Important Safety Guards carefully. · It is normal for a small amount of smoke and a light odor to be produced the first time it is used. They are not harmful and should disappear after the iron has been allowed to steam. Filling with water · Ensure the iron is unplugged. · Rest the iron on heel and tilt it forward approximately 1 inch. If the iron is equipped with a covered filling inlet, open the filling inlet by sliding the cover down. · Fill with water (containing no additives) to the max mark on the water tank. If you need to add water during ironing, UNPLUG the iron and follow the steps above. Ensure iron heats back to temperature afterwards, that means thermostat light will go out. Selecting the Temperature Set the temperature control dial according to the fabric you are ironing. [. . . ] Care should be taken to arrange the cord so that it cannot be pulled or tripped over unintentionally. · Your Rowenta appliance is intended for household use only. If your iron is equipped with auto-off and the iron is not moved while it is plugged in, an internal safety switch will turn it off. It will turn off in 8 minutes if left vertically or in 30 seconds if left on its soleplate or tipped over. Wait until iron is fully reheated before use. 8 min. Anti-Drip System (depending on model) Burst of steam This feature is ideal for removing stubborn wrinkles or pressing in sharp creases in horizontal use. [. . . ]