User manual ROSE DISPLAYS ANOQUICK WITH PEG AND MULTICLIPS

[. . . ] AnoQuickTM with Peg Instruction Sheet Parts AnoQuick 12A300R Pegs 06-1920 MultiClip 1UP-0100 End Caps 06-5525 Instructions for Hanging Step 1 When using AnoQuick to hang 1/8" Sintra or an equally heavy substrate, have your printer punch two 1/4" holes along the top and bottom edges of print -- or only the top if no bottom holder is being used. [. . . ] 1 Note: Each hole must be centered 1/4" in from the edge of the substrate. Figure 1 Step 2 Push both parts of the peg together through each of the punched holes. 2 Figure 2 Step 3 Install MultiClip in the top AnoQuick Holder. Holding clip at slight angle, first insert one round end, then press down on other round end and push MultiClip into holder. 3 Note: For OneUp applications place the MultiClip in the center of the AnoQuick Holder. Figure 3 The AnoQuick is a registered trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part # 02INSAnoQw/PegMCEndcap Incept-8. 15. 02 AnoQuickTM with Peg Instruction Sheet Parts AnoQuick 12A300R Pegs 06-1920 MultiClip 1UP-0100 End Caps 06-5525 Instructions for Hanging Step 4 Slide AnoQuick onto substrate. 4 Note: This is the easiest way to safely hang heavier substrates. Figure 4 Step 5 Push end caps into place. 5 Note: To remove poster with pegs, simply rotate end cap up out of the way. Step 6 Suspend poster. Figure 5 Important note: Please save and reuse the AnoQuick Holder, Pegs, End Caps and MultiClips for future projects. The AnoQuick is a trademark of Rose Displays, Ltd. [. . . ] Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. [. . . ]