User manual PROEL M-8

[. . . ] This marking shown on the product or its literature, indicates that it should not be disposed with other household wastes at the end of its working life. To prevent possible harm to the enviroment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources. Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contract. [. . . ] This LED has two function: If the PEAK LED lights permanently this means that you have activated the SOLO switch of this channel. If the PEAK LED flashes this means that the input signal is near to the CLIPPING point. IMPORTANT: if the LED PEAK flashes reduce the level of the input signal using the GAIN control. This switch allows you to hear signals through your headphones or control room outputs. The dual-purpose MUTE/ALT 3-4 switch serves two functions: muting, and signal routing where it acts as an extra stereo bus. It adjusts the level of the channel signal and send it to the MAIN MIX and to the CTRL ROOM/PHONES outputs on master section. Rotate this detented switch to select the preset effect you want to use. Dense, smooth reverb with long tail, long pre delay and some early reflections. The VARIATIONS vary from "bright" (1-8) to "warm" (9-16) starting from long tail to short tail for each one. Dense, smooth reverb with short tail, normal pre delay and increased early reflections. The VARIATIONS vary from "bright" (1-8) to "warm" (9-16) starting from long tail to short tail for each one. LARGE ROOM - This type of reverb reproduces the more intimate ambience of natural room acoustics. The VARIATIONS vary from "bright" (1-8) to "warm" (9-16) starting from long tail to short tail for each one. SMALL ROOM - This type of reverb reproduces the more intimate ambience of natural room acoustics. The VARIATIONS vary from "bright" (1-8) to "warm" (9-16) starting from long tail to short tail for each one. The VARIATIONS vary from "bright" (1-8) to "warm" (9-16) starting from long tail to short tail for each one, alternating hall, tape, spring or plate types of reverb. The VARIATIONS vary from "bright" (1-8) to "warm" (9-16) starting from long tail to short tail for each one, alternating hall, tape, spring or plate types of reverb. PLATE - This is a simulation of metal plate reverb, as used on classic recordings from the '70s and '80s. FLANGER - Typical modulation effect, creates a strong sweeping effect, particularly effective on rock electric guitar, lead and rhythm. When "TAP DELAY" effect is selected, by pushing at least two times this button, it's possible to set the desired delay time, according to music rhythm. This LED is activated only when Tap-Delay effect is recalled and flashes in sync with the delay time set by pushing the TAP button. 3mm) unbalanced (TS) jack for temporary, normally open footswitch (not supplied), suggested footswitches are PROEL model PFS20, PFS24, PFS29. [. . . ] The MAIN MIX (58) fader now acts like a master volume knob for all your mic/line inputs. Adjust this knob until you're getting good levels into your PC recording DAW software. ROOM/PHONES (46) knob now controls the level of your headphones (or studio monitors), but does not affect recording levels in your PC. You can set this level to a comfortable setting (or even off ) without affecting what gets recorded. [. . . ]