User manual PHILIPS SCD580/00

[. . . ] 2 Linking parent unit and baby unit Functions and feedback on the baby unit 5. 10 Key lock 6 5 10 Storage 11 Ordering accessories 12 Guarantee and support 13 Frequently asked questions 1 Introduction Congratulations on your purchase and welcome to Philips AVENT!To fully benefit from the support that Philips AVENT offers, register your product at www. Philips AVENT is dedicated to producing caring, reliable products that give parents the reassurance they need. [. . . ] The microphone sensitivity determines what noise level the baby unit picks up, e. You will want to hear when your baby cries, but you may be less interested in its babbling 1 Select ‘Sensitivity’ in the menu with the + and - buttons and press OK to confirm. 2 Use the + and - buttons to increase or decrease the microphone sensitivity. If your baby does not make any sound, the speaker of the parent unit is off. If your baby makes softer sounds, the speaker of the parent unit does not go on. Low The speaker of the parent unit only goes on if the baby makes loud sounds, for instance because it is crying. 19 E N GL IS H Use the + button to go to the next option or the - button to go to the previous option. €• If all four segments are filled, the sensitivity is at its highest level. 3 Eco Max mode This baby monitor has Smart Eco that automatically reduces the DECT signal from the baby unit as the distance between parent unit and baby unit becomes shorter. If you want to save even more energy and to stop radio transmission, activate the Eco Max mode in the menu of the parent unit. As soon as the baby makes a sound, the DECT signal of the baby unit automatically switches on again. C Caution: In Eco Max mode, the parent unit receives feedback from the baby unit with a delay. When your baby makes a sound, the baby unit first has to reactivate radio transmission before it can send feedback to the parent unit. 2 Activating Eco Max mode 1 Select ‘Eco Max’ in the menu with the + and buttons and press OK to confirm. 2 When the display shows ‘Turn On’, press OK to switch on the Eco Max mode. If you do not press OK, the parent unit leaves the menu and the Eco Max mode remains off. €• Before you select the Eco Max mode in the menu of the parent unit, make sure that the parent unit and baby unit are within operating range, see section ‘Operating range’ in chapter ‘Using the baby monitor’. In Eco Max mode you do not receive feedback when the parent unit is out of range of the baby unit. €• If there is no radio transmission from the baby unit to the parent unit in Eco Max mode, the sound level lights are off. The sound level lights go on when the baby unit reactivates radio transmission because the baby makes a sound above the selected sensitivity level. €• If you want to operate the baby monitor in Eco Max mode, make sure the microphone sensitivity is set between level 1 and level 3. If the microphone sensitivity is set at level 4, the baby unit does not switch off radio transmission in Eco Max mode. [. . . ] the specified operating range of the baby monitor is 330 metres/1000 feet. Inside your house, the operating range is limited by the number and type of walls and/ or ceilings in between. €• The baby unit and the parent unit are probably close to the outer limits of the operating range. Please note that it takes about 30 seconds each time before a connection between the units is established. [. . . ]