User manual PHILIPS GC6602

[. . . ] Read this user manual, the important information leaflet, and the quick start guide on the packaging carefully before you use the appliance. €3) 1 Water tank filling funnel 2 Carry lock (specific types only) 3 ’Iron ready’ light 4 Calc-Clean button with Calc-Clean light 5 Steam trigger 6 Temperature dial 7 Heel 8 Supply hose 9 On/off switch 10 Mains cord 11 Mains plug 12 Hose storage compartment 13 Water tank 14 Smart Calc-Clean container Setting the temperature To set the required ironing temperature,  turn the temperature dial to the appropriate position. The appliance adjusts the steam automatically, depending on the ironing temperature set. [. . . ] 6 Press and hold the Calc-Clean button for 2 seconds until you hear short beeps (Fig. 7 During the Calc-Clean process, you hear short beeps and a pumping sound. Wait approximately 2 minutes for the appliance to complete the process (Fig. 8 When the Calc-Clean process is completed, the iron stops beeping (Fig. 9 Wipe the iron with a piece of cloth and put it back on the base station (Fig. 7 10 As the Smart Calc-Clean container becomes hot during the Calc-Clean process, wait approx. 11 Carry the Smart Calc-Clean container to the sink, empty it and store it for future use (Fig. Make sure that you empty the Calc-Clean container before you start the Calc-Clean process. Note: During the Calc-Clean process, clean water may come out of the soleplate if no scale has accumulated inside the iron. 8 ENGLISH Safety auto-off mode (specific types only) -- To save energy, the steam generator switches off automatically when it has not been used for 15 minutes. -- To reactivate the steam generator, set the on/off switch to ‘off ’ position and then to ‘on’ position. Troubleshooting This chapter summarises the most common problems you could encounter with the appliance. € If you are unable to solve the problem with the information below, visit www. Com/support for a list of frequently asked questions or contact the Consumer Care Centre in your country. [. . . ] Let the iron heat up until the ‘iron ready’ light lights up steadily. 30 SVENSKA Introduktion Grattis till inköpet och välkommen till Philips!Allmän beskrivning (Bild 3) 1 Påfyllningstratt till vattentank 2 Bärlås (endast på vissa modeller) 3 Klarlampa för strykning 4 Avkalkningsknapp med avkalkningslampa 5 Ångaktivator 6 Temperaturvred 7 Häl 8 Tillförselslang 9 Strömbrytare 10 Nätsladd 11 Stickkontakt 12 Utrymme för slangförvaring 13 Vattentank 14 Behållare för smart avkalkning Ställa in temperaturen Ställ in önskad stryktemperatur genom att vrida temperaturvredet till lämpligt läge. [. . . ]