User manual PHILIPS GC4541/20
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual PHILIPS GC4541/20. We hope that this PHILIPS GC4541/20 user guide will be useful to you.
Manual abstract: user guide PHILIPS GC4541/20
Detailed instructions for use are in the User's Guide.
[. . . ] Type of water to use This appliance has been designed to be used with tap water. However, if you live in an area with hard water, fast scale build-up may occur. Therefore, it is recommended to use distilled or demineralized water to prolong the lifetime of the appliance. Do not use perfumed water, water from the tumble dryer, vinegar, starch, descaling agents, ironing aids, chemically descaled water or other chemicals, as they may cause water spitting, brown staining or damage to your appliance. [. . . ] After 1 to 3 months of use, the Calc-Clean reminder light starts flashing to remind you to use the Quick Calc Release function (Fig. This is to remove scales collected from your iron to prolong its life. When the Calc-Clean reminder light is flashing, the iron does not heat up. Tip: The Quick Calc Release function can be used at any time, even when the reminder light is not activated yet. 5 Gently shake the appliance to allow scale particles to fall out (Fig. 6 Insert the Quick Calc Release collector back into the appliance (Fig. 7 Push down the lever (âclickâ) to lock the collector (Fig. Calc-Clean (specific types only) IMPORTANT: After 1 to 3 months of use, the Calc-Clean reminder light starts flashing to remind you to use the Calc-Clean function (Fig. Tip: The Calc-Clean function can be used at any time, even when the reminder light is not activated yet. 1 Make sure that the steam slider is set to âsteam offâ position. 10 ENGLISH 2 Make sure there is enough water (more than 3/4) in the water tank. If there is not enough water, unplug the iron, fill the water to MAX indication (Fig. 4 Unplug the iron when the âiron readyâ light stops breathing (Fig. Keep pushing the Calc-Clean button and gently shake the iron forth and back until all water in the water tank has been used up (Fig. Scales is flushed out, steam and boiling water also come out of the soleplate. Note: Repeat steps 2 to 5 if the water that comes out of the appliance still contains scale particles. 6 Plug in the appliance and let the appliance heat up to dry the soleplate. Move the appliance gently over a piece of cloth to remove any water stains on the soleplate (Fig. Troubleshooting
This chapter summarises the most common problems you could encounter with the appliance. Â¯If you are unable to solve the problem with the information below, visit www. Com/support for a list of frequently asked questions or contact the Consumer Care Centre in your country. The steam setting is set to âsteam offâ The iron is not ready. [. . . ] Rinse the water tank and do not put any perfume or chemicals into the water tank. Continue ironing in horizontal position and wait a while before you use the steam boost function again. Wait until the iron is ready (the light on the display panel stops flashing). The iron does not produce a steam boost You have used the steam boost function too often within a short period. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE PHILIPS GC4541/20
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual PHILIPS GC4541/20 will begin.