User manual PHILIPS CSS2123

[. . . ] ___________________________ Compliance Note · This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. [. . . ] The batteries supplied do not contain the heavy metals mercury and cadmium. Nevertheless, in many areas batteries may not be disposed of with your household waste. Please ensure you dispose of batteries according to local regulations. Visit www. dtsc. ca. gov/hazardouswaste/ perchlorate. Congratulations on your purchase, and welcome toPhilips!Tofullybenefitfromthesupportthat Philips offers, register your SoundBar at www. philips. com/welcome. Main unit 1 2 a SURR Lights up when virtual surround mode is on. b Source indicators · COAXIAL: Lights up when you switch to · OPTICAL: Lights up when you switch to · AUX: Lights up when you switch to · MUSIC iLINK: Lights up when you switch to Music iLink input source. coaxial input source. EN 5 English Care of the environment 4 Your SoundBar Remote control f BASS +/g MUTE Increase or decrease bass. Mute or restore volume. 1 2 7 3 6 4 5 a (Standby-On) Switch the SoundBar on or to standby. b Source buttons · AUX: Switch your audio source to the · OPTICAL: Switch your audio source to · COAXIAL: Switch your audio source to · MUSIC iLINK: Switch your audio source to the MUSIC iLINK connection. AUX connection. c SURROUND d TREBLE +/e VOL +/6 EN Switch to virtual surround mode on or off. Increase or decrease volume. Replace battery Warning · Danger of explosion if battery is incorrectly replaced. · The product/remote control may or may not contain a Replace only with the same or equivalent type. Keep the battery out of reach of children at all times! 5 Caution · The battery contains perchlorate material, handle it with care. · On non-Philips TV, select `PCM' (PCM) or `Standard' (Standard) from the TV audio menu. · On other devices such as DVD player or Bluray player, Select `PCM' (PCM) from the audio output of the device. Note · Due to copyright restrictions, the broadcaster may mute PCM audio over Digital Audio Output for certain channels, shows, or segments during the broadcast. Option 3: Connect audio through analog audio cables Basic quality audio Using an analog cable, connect the AUX connectors on your SoundBar to the audio connectors on the device. VCR Option 1: Connect audio through a digital optical cable Best quality audio Using an optical cable, connect the OPTICAL connector on your SoundBar to the OPTICAL OUT connector on the device. The digital optical connector might be labeled SPDIF, SPDIF OUT, or OPTICAL. TV Option 2: Connect audio through a digital coaxial cable Good quality audio Using a coaxial cable, connect the COAXIAL connector on your SoundBar to the COAXIAL/ DIGITAL OUT connector on the device. The digital coaxial connector might be labeled DIGITAL AUDIO OUT. EN 9 English 6 Use your SoundBar Change treble or bass Change the high frequency (treble) or low frequency (bass) settings of the SoundBar to suit your video or music. This section helps you use the SoundBar to play audio from connected devices. Before you start · Make the necessary connections described in the quick start guide and the user manual. · Switch the SoundBar to the correct source for other devices. Play audio from TV or other devices Press TREBLE +/- or BASS +/- to increase or decrease treble or bass. · The Source indicators on the front panel blink thrice when the treble or bass is set to either minimum or maximum. Surround sound mode Experience an immersive audio experience with surround sound modes. Press the Source buttons to select the audio output of the connected device. Press SURROUND repeatedly to switch surround mode on or off. Adjust the volume » When surround mode is on, the SURR on the front panel lights up. MP3 player To increase or decrease volume, press VOL +/-. · The Source indicators on the front panel blink thrice when the volume is set to either minimum or maximum. · The current Source indicator on the front panel blinks continuously. [. . . ] · A product that requires modification or adaptation to enable it to operate in any country other than the country for which it was designed, manufactured, approved and/or authorized, or repair of products damaged by these modifications. · A product used for commercial or institutional purposes (including but not limited to rental purposes). · Product lost in shipment and no signature verification receipt can be provided. Contact Customer Care Center at: 1-866-309-0846 REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY FOR THE CONSUMER. [. . . ]