User manual PANASONIC TX-39CW304

[. . . ] To operate your TV in extreme ambient conditions may cause damage of the device. IMPORTANT - Please read these instructions fully before installing or operating WARNING: Never let people (including children) with reduced physical, sensory or mental capabilities or lack of experience and / or knowledge use electrical devices unsupervised. € For ventilation purposes, leave a free space of at least 10 cm all around the set. € Do not place the TV on sloping or unstable surfaces, the TV may tip over. [. . . ] If you want to connect a device to the TV, make sure that both the TV and the device are turned off before making any connection. English - 7 - Getting Started First Time Installation - USB Connections To Switch the TV On Connect the power cord to the 220-240V AC, 50 Hz. Note: If the TV does not switch into standby mode after plugging the power plug into the mains socket, check if the ” on the TV(switch position may power switch button “ differ depending on the model) is in position “|” (on-position). Aerial Installation If you select Aerial option from the search type selection screen, the television will search for digital terrestrial TV broadcasts. After all the available stations are stored, the Channel List will be displayed on the screen. While the search continues a message will appear, asking whether you want to sort channels according to the LCN(*). (*) LCN is the Logical Channel Number system that organizes available broadcasts in accordance with a recognizable channel sequence (if available). If you select Cable option and press OK button on the remote control a confirmation screen will be displayed. Note: Searching duration will change depending on the selected search step. To switch on the TV from standby mode either: Press the “ ” button, P+ / P- or a numeric button on the remote control. Cable Installation To Switch the TV Off Press the “ ” button on the remote control or press and hold the control switch on the TV, so the TV will switch to standby mode. Pressing the MENU button English - 9 - TV Menu Features and Functions Picture Menu Contents Mode Contrast Brightness Sharpness Colour Power Save Mode Backlight (Optional) Noise Reduction Dynamic Contrast Colour Temp Picture Zoom You can change the picture mode to suit your preference or requirements. Picture mode can be set to one of these options: Cinema, Game, Sports, Dynamic and Natural. The backlight function will be inactive if the Power Save Mode is set to Eco. The backlight cannot be activated in VGA, Media Browser mode or while the picture mode is set to Game. If the broadcast signal is weak and the picture is noisy, use the Noise Reduction setting to reduce the amount of noise. Advanced Settings You can change the Dynamic Contrast ratio to desired value. Note: Auto (Only available in Scart mode with SCART PIN8 high voltage/low voltage switching) HDMI True Black Film Mode Skin Tone Colour Shift RGB Gain Reset Autoposition (in PC mode) H Position (in PC mode) V Position (in PC mode) Dot Clock (in PC mode) Phase (in PC mode) While watching from HDMI source, this feature will be visible in the Picture Settings menu. Films are recorded at a different number of frames per second to normal television programmes. Turn this feature on when you are watching films to see the fast motion scenes clearly. You can configure the colour temperature values using the RGB Gain feature. This item shifts the image horizontally to the right hand side or left hand side of the screen. [. . . ] Note: If the TV fails to come on after the upgrade unplug the TV for 2 minutes and plug in again. Troubleshooting & Tips Tv will not turn on Make sure the power cord is plugged in securely to wall outlet. € Check if you have entered the correct channel frequency if you have done manual tuning. English - 13 - • The picture quality may degrade when two devices are connected to the TV at the same time. [. . . ]