User manual OREGON RMR329PA

[. . . ] When disposing of this product, ensure it is collected separately for special treatment. Placement of this product on certain types of wood may result in damage to its finish for which Oregon Scientific will not be responsible. consult the furniture manufacture's care instructions for information. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. The following information is not to be used as contact for support or sales. Please call our customer service number (listed on our website at www. Press any other key to turn the alarm off and activate it again after 24 hours. Place the sensor within 30 m (98 ft) of the main unit using the table stand or wall mount. NOTE The technical specifications for this product and the contents of the user manual are subject to change without notice. Operation is subject to the following two conditions: 1) This device may not cause harmful interference. 2) This device must accept any interference received, including interference that may cause undesired operation. TEMP: Toggle in / out temperature settings The transmission range may vary depending on many factors. You may need to experiment with various locations to get the best results. NOTE We recommend that you use alkaline batteries with this product for longer usage and consumer grade lithium batteries in temperatures below freezing. To auto-scan between sensors: Press and hold TEMP for 2 seconds to display the sensor's data for 5 seconds. Outdoor sensor: The main unit will automatically search for the outdoor sensor. The sensor reception icon in the remote sensor area shows the status: ICON DESCRIPTION Main unit is searching for sensor(s) A channel has been found The sensor cannot be found. NOTE If the sensor is not found, check the batteries, obstructions, and remote unit location. [. . . ] This product is designed to synchronize its clock automatically with a clock signal. If the signal is weak, it can take up to 24 hours to get a valid signal. NOTE To save battery life, the projector and backlight will only operate continuously when adapter is installed. [. . . ]