User manual OBH NORDICA LH42Q8S0

[. . . ] Always disconnect the appliance from the mains power supply when it is unattended and before assembling, dismantling or cleaning it. Remember: you may injure yourself if you use the appliance incorrectly. Do not use the appliance if it is not working properly or if it has been damaged. In this case, contact an authorized service centre (see the list in the service booklet). [. . . ] It is not intended to be used in the following environments, in which the guarantee shall not apply: - Kitchen work areas in shops, offices and other working environments. - In kitchen areas reserved for staff in shops, offices and other Switch off the appliance and unplug it from the electrical power supply before changing accessories or approaching parts that move in use. Refer to the instructions to obtain the appropriate operating time and speed settings for each accessory. Refer to the instructions for correct fitting and assembly of your accessories. Refer to the instructions for initial and regular cleaning of surfaces in contact with foodstuff, and for cleaning and maintenance of your appliance. eUROPEAN MARKETS ONLY · This appliance shall not be used by children. This appliance may be used by persons with reduced physical, Sensory or mental capabilities, or whose experience or knowledge is not sufficient, provided they are supervised or have received instruction to use the appliance safely and understand the dangers. Your appliance contains valuable materials which can be recovered or recycled. The accessories supplied with the model that you have purchased are shown on the label on the top of the packaging. WARNING: Read the instructions for use carefully before using your appliance for the first time: the manufacturer shall accept no liability in the event of any use that does not comply with the instructions. The appliance can only operate when the jug (C) or the accessories (D or E) are correctly positioned and locked on the motor unit (A). Before you use your appliance for the first time, clean all the accessories (C, D, E, F) using hot soapy water, except for the motor unit (A). WARNING: The blades are extremely sharp so handle them carefully when using and cleaning the appliance. Verify that the packaging has been removed before using the appliance. Important note: Turn the speed selector (B) to "0" before placing the Blender jug or the accessories on the motor unit. The appliance will only start if the jug or the accessory is correctly Positioned and locked on the motor unit. 2) · Place the blade assembly (C1, C2, C3) on the jug (C4) and lock it by Put the ingredients in the assembled jug without exceeding the maximum level indicated: * 1. 25 L for thick preparations * 1 L for liquid preparations · Warning: Do not process boiling liquids (over 80ºC/176ºF) in the blender jug. Then turn the blender jug (C4) a quarter turn until the closed lock is aligned with the arrow of the jug (Fig. Plug in the unit and turn it on by turning the speed selector to the desired position or apply a few pulses. 2 positions are possible for the jug handle to the right or to the left of the motor unit. Do not use one of the blender accessories (D, E) continuously for more than 30 seconds. [. . . ] Remove the seal (C3) and clean the blade support and blade using running water. After cleaning, remember to correctly fit the seal (C3 or D2) back onto the blade unit. Note: Incorrectly fitting the seal can result in ingredients leaking from the blender jug, spice mill or herb chopper. The plastic, glass or steel jug (C4), the lid (C5), the cap (C6), the spice mill bowl (E2), the herb chopper bowl (D3), as well as the spatula (F) can be cleaned in the upper basket of a dishwasher using the "ECO" or "REDUCED SALT" programme. [. . . ]