User manual MSI MS-7599 G52-75991X7 V3.0

[. . . ] Ths equpment generates, uses and can radate rado frequency energy and, f not nstalled and used n accordance wth the nstructons, may cause harmful nterference to rado communcatons. However, there s no guarantee that nterference wll not occur n a partcular nstallaton. If ths equpment does cause harmful nterference to rado or televson recepton, whch can be determned by turnng the equpment off and on, the user s encouraged to try to correct the nterference by one or more of the measures lsted below. Notce 1 The changes or modficatons not expressly approved by the party responsble for complance could vod the user's authorty to operate the equpment. [. . . ] Lne-In (Blue) - Lne In, s used for external CD player, tape-player or other audo devces. If you nstall two IDE devces on the same cable, you must configure the drves separately to master / slave mode by settng jumpers. To clear the warnng, you must enter the BIOS utlty and clear the record. When connectng the wre to the connectors, always note that the red wre s the postve and should be connected to the +12V; the black wre s Ground and should be connected to GND. If the manboard has a System Hardware Montor chpset on-board, you must use a specally desgned fan wth speed sensor to take advantage of the CPU fan control. You can nstall Control Center utlty that wll automatcally control the CPU fan speed accordng to the actual CPU temperature. ⷠFan cooler set wth 3 or 4 pns power connector are both avalable for CPUFAN. These connectors are for electrcal connecton to the front panel swtches and LEDs. Ths connector allows you to connect the front panel audo and s complant wth Intel® Front Panel I/O Connectvty Desgn Gude. There s a CMOS RAM onboard that has a power supply from an external battery to keep the data of system configuraton. Wth the CMOS RAM, the system can automatcally boot OS every tme t s turned on. If you want to clear the system configuraton, set the jumper to clear data. Ths secton wll explan how to change your manboard's functon through the use of swtch. Ths secton wll explan how to change your manboard's functon through the use of button. You can use them to change FSB clock at any tme under the operatng system. In order to ncrease the success rate, you should set the voltage n BIOS properly. ⷠAfter each of the adjustments, ths feature should be shut down. Therefore, when you complete the adjustment, check whether OC Dal LED (optonal) s on or off, f OC Dal LED (optonal) s stll lt, press the button and then check agan. The PCI slot supports LAN card, SCSI card, USB card, and other add-on cards that comply wth PCI specficatons. When addng or removng expanson cards, make sure that you unplug the power supply first. Meanwhle, read the documentaton for the expanson card to configure any necessary hardware or software settngs for the expanson card, such as jumpers, swtches or BIOS configuraton. The IRQ, acronym of nterrupt request lne and pronounced I-R-Q, are hardware lnes over whch devces can send nterrupt sgnals to the mcroprocessor. [. . . ] Select [1T] makes SDRAM sgnal controller to run at 1T (T=clock cycles) rate. DCT Unganged Mode Ths feature s used to Integrate two 64-bt DCTs nto a 128-bt nterface. When the system does not access memory over a perod of tme, t wll automatcally reduce the memory power supply. Adjust PCI-E Frequency (MHz) Ths field allows you to select the PCIE frequency (n MHz). [. . . ]