User manual MSI MS-7104

[. . . ] 0 Revision History First release of V-Series with VIA P4M800/VT8237R chipsets Date January 2005 Always read the safety instructions carefully. The openings on the enclosure are for air convection hence protects the equipment from overheating. Make sure the voltage of the power source and adjust properly 110/220V before connecting the equipment to the power inlet. Always Unplug the Power Cord before inserting any add-on card or module. [. . . ] Press down the fan until its four clips get wedged in the holes of the retention mechanism. Connect the fan power cable from the mounted fan to the 3-pin fan power connector on the board. Confirm if your CPU cooler is firmly installed before turning on your system. You can install either single- or double-sided modules to meet your own needs. Then push it in until the golden finger on the memory module is deeply inserted in the socket. For the updated supporting memory modules, please visit our Web site at http://www. Before inserting the power supply connector, always make sure that all components are installed properly to ensure that no damage will be caused. Power supplies of 300watt (and up) are highly recommended for system stability. To connect to the ATX power supply, make sure the plug of the power supply is inserted in the proper orientation and the pins are aligned. You can connect up to four hard disk drives, CD-ROM, 120MB Floppy and other devices. You must configure second hard drive to Slave mode by setting the jumper accordingly. If you install two hard disks on cable, you must configure the second drive to Slave mode by setting its jumper. To clear the warning, you must enter the BIOS setting and clear the status. The CPU_FAN (processor fan) and SYS_FAN (system fan) support system cooling fan with +12V. When connecting the wire to the connectors, always note that the red wire is the positive and should be connected to the +12V, the black wire is Ground and should be connected to GND. If the mainboard has a System Hardware Monitor chipset on-board, you must use a specially designed fan with speed sensor to take advantage of the CPU fan control. Ports support 1st generation Serial ATA data rates of 150MB/s and are fully compliant with Serial ATA 1. The mainboard provides two front panel connectors for electrical connection to the front panel switches and LEDs. [. . . ] Frequency/Voltage Control Use this menu to specify your settings for CPU/AGP frequency/voltage control and overclocking. Load Optimized Defaults Use this menu to load the BIOS values for the best system performance, but the system stability may be affected. The items in this submenu includes some important settings of CPU, AGP, DRAM and overclocking functions. Current FSB Frequency It shows the current clock frequency of the front side bus. [. . . ]