User manual MIELE W 1930 WASHING MACHINE OPERATING MANUAL

[. . . ] Operating instructions Washer W 1930 To prevent accidents and machine damage, read these Operating Instructions before installation or use. U M. -Nr. 5 Preparation for use Operating Instructions USER MANTENANCE Instructions INSTALLATION INSTRUCTIONS Technical data . 46 2 Guide to the machine a Supply cable b High pressure intake hoses c Flexible drain hose, with detachable swivel elbow d Detergent dispenser drawer e Control panel f Drum door g Access panel for drain pump and filter h Four height adjustable feet i Panel for emergency door release (door hinged right) and for drainage (door hinged left or right) j Panel for emergency door release (door hinged left) 3 Guide to the machine Detergent dispenser drawer Compartment i - for the pre-wash. Compartment p (with lid) - for fabric softener or starch. a "Delay start" button. [. . . ] ^ Replace the filter and gasket in the reverse order and reconnect the hose. If the connection drips and cannot be tightened any further, the gasket may need to be replaced. Always replace the intake filter after cleaning it. 24 Problem solving guide Any work done on the electrical components of this appliance should only be performed by a qualified technician in accordance with all local and national codes and regulations. Unauthorized repairs may result in personal injury and machine damage. What to do if, . The "Check indicator lamps are flashing? ­ the fuse or circuit breaker has not tripped. ­ Turn the program seThere is power and the lector to the "Finish / "ON" indicator lamp is on, but the program selector Start" position. " The "Check p" indicator ­ The inlet valve is not opened far enough. The "Check q" indicator ­ Clean the drain pump lamp is flashing. (max drain height = 4 feet) 25 Problem solving guide What to do if, . the "Pre-wash", "Main wash" or "Rinse 1-2" indicator lamp is flashing?Select a spin speed setting. The spin speed selector has been set to "Without final spin". ­ Turn the program selector to "Spin". The child-safety feature is activated, and the program has been changed. The load was not evenly distributed in the drum, and the laundry was spun at a reduced speed to protect the machine. The machine The four feet are not restshakes during the spin ing evenly on the floor. The "ON" indicator lamp is flashing? Go back to the program originally selected. Mix large and small items in a load to avoid imbalance. Clean the drain pump or lint trap. Remove the shipping struts. 26 Problem solving guide What to do if, . In spite of adequate water supply, the water flows slowly into the machine?Large residues of detergent remain in the dispenser drawer? Cause . . Clean the water inlet filters. The water pressure is too low. Detergent used with a water softener tends to become sticky. Fabric softener is not completely dispensed or water remains in the compartment?The dispenser drawer was not pushed in when the fabric softener was being dispensed. [. . . ] If the Program Selector is turned to its original position, the "On" lamp will stop flashing. To change a program once the Program Lock is activated: ^ Turn the Program Selector to "Finish/Start". After about 30 seconds, the sequence indicator lamps will start flashing in succession. A new program can be selected as soon as the "On" lamp is the only one remaining lit. High water level (only in "Cottons" rinses) Where rinse results are particularly important (e. g. [. . . ]