User manual KRUPS XN304T

[. . . ] Please read the instructions and safety precautions before operating the appliance. Le gel ou avant une réparation/Emptying the system before a period of Non-use and for frost protection, or before a repair The voltage of the power source is Sensory or mental capabilities, or the same as that specified on the Protect the appliance from direct whose experience or knowledge rating plate. Sunlight effect, prolonged water is not sufficient, provided they Are supervised or have received Carefully before using your · This appliance is intended to be used instruction to use the appliance safely The appliance must only be New appliance for the first in households and similar applications and understand the dangers. Keep them in a place only such as: staff kitchen areas in · Children shall not use the device as · Do not pull the cord over sharp edges, Where you can find and refer shops, offices and other working a toy. [. . . ] A lways completely close the lever drip tray and drip grid to avoid spilling proper functioning of your machine Never immerse the appliance or part and never lift it during operation. Over its lifetime and that your coffee D o not use any strong cleaning agent experience is as perfect as the first Never put the appliance or part of it in · D o not put fingers under coffee D o not put fingers into capsule Dangerous and can lead to fatal compartment or the capsule shaft. T o clean machine, use only clean Pass them on to any Do not open the appliance. W ater could flow around a capsule · When not perforated by the blades remove the plastic film and dispose. Do not put anything into any T his appliance is designed for 2 Grille d'égouttage + support de tasse Drip grid + cup support 3Réservoir à capsules pour 9­11 capsules Capsule container for 9 ­ 11 used capsules Remove the plastic film from the drip grid. Insert the remaining cable in the cable guide under the machine and put the machine in the upright position. To turn the machine On, press either the Espresso the Lungo button to rinse the machine. Close the lever and place a cup under the coffee Voyants clignotants: la machine est en mode Lift the lever completely and insert the capsule. Rinse then fill the water tank with fresh drinking préchauffage. To turn the machine On, press either the Espresso During operation and refer to the safety precautions to avoid possible Harm when operating the appliance During heat up, you can press the coffee button when it's still blinking. For a Latte Macchiato glass fold the cup support Press the Espresso (40 ml) or the Lungo Down again when removing the glass to avoid any automatically. Lift and close the lever to eject the capsule into the used capsule container. To turn the machine off before automatic Power Off, press both the Espresso and Lungo buttons simultaneously. With the machine OFF, press and hold the Espresso button for 3 seconds. To change this setting press the Espresso button: One time for Auto Off mode after 30 minutes. To enter the emptying mode, press both the Espresso and Lungo button to turn the machine off. LEDs will blink fast 3 times to confirm machine has been reset to factory settings. With machine turned off, press and hold down the Lungo button for 5 seconds. LEDs will then continue to blink normally, as heating up, until ready. To assemble the cup support and the drip tray: take off the grid, place them side by side and clip the drip tray to the cup support. [. . . ] Krups guarantees this product against defects in materials and workmanship for a period of two years from the date of purchase. During this period, Krups will either repair or replace, at its discretion, any defective product at no charge to the owner. Replacement products or repaired parts will be guaranteed for only the unexpired portion of the original guarantee or six months, whichever is greater. This limited guarantee does not apply to any defect resulting from accident, misuse, improper maintenance, or normal wear and tear. [. . . ]