User manual KRUPS INTUITION ESSENTIAL YY4371FD

[. . . ] Effet lumineux respirant (qui s'intensifie et s'éteint progressivement) - Pulsing light effect (which intensifies and goes out gradually) - Flackernder Lichteffekt Hell leuchtende Taste - Toets is fel verlicht - Oplyst felt, konstant/klart lys - Knapp med stabilt, sterkt lys - Starkt Thank you for purchasing your KRUPS espresso machine with bean grinder. Designed and manufactured in France to give you "cafe" quality drinks with the greatest ease, your KRUPS machine makes Espresso, Ristretto, and Lungo, and you can also manually make milk froth to create other milk-based drinks: Cappuccino, Latte Macchiato, Café Latte, etc. They will guide you in the use of your machine and brighten up your coffee breaks. Your KRUPS espresso machine is equipped with advanced technologies and an intuitive touchscreen interface; in order to obtain the best extraction possible with total ease, to reveal maximum aromas and flavours from the freshly ground coffee. [. . . ] Please note: There are 2 preheating times: one for the machine and one for the steam. Important: Steam production stops automatically depending on the steam time selected previously. You can press "START/STOP" before the end of the cycle if the amount of milk froth is sufficient. If you do not press the "START/STOP" button, the machine returns to its initial position after 2 minutes. Advice and Tips: To make the milk froth, fill 1/3 of the cup with milk. Immerse the steam nozzle in the milk and hold it against the edge of the cup. This technique creates a milk whirlpool, which makes the optimal amount of foam. By following these tips, you will create a barista-quality milk froth ready to be used to make a milky drink. cLEANING THE STEAM NOZZLE Important: In order to obtain identical froth each time, we recommend that you carefully clean the tube and its connector AFTER EACH USE. It is recommended to clean the steam nozzle when not used for a longer period (more than 2 days) Danger: After using the steam function, the nozzle may be hot, we advise you to wait a few moments before handling it. Wash it with water and some non-abrasive washing up liquid with a brush. The steps for cleaning the steam nozzle can be found in section 6 ­ CLEAN YOUR STEAM NOZZLE, Fig 1 to 8. To remove any traces of milk from the steam nozzle, place a container under the nozzle and launch a hot water drink. If steam does not come out, the nozzle may be clogged: unclog with the needle supplied. Press ­ You can adjust the volume of the drink according to your preference. However, it is not Possible to make 2 cups at the same time: the "x2" function is not available. The machine preheats (the lights flash), then the hot water starts to flow. Carrying out proper maintenance will prolong the life of your machine and preserve the authentic taste of your coffee. Important: To make things simpler and more efficient, your Krups machine has an automated cleaning system: a tablet is all that's needed!We guarantee thorough cleaning at high temperatures for a perfect coffee every time. mAINTENANCE OF THE COFFEE GROUNDS COLLECTOR AND DRIP TRAY The drip tray receives the waste water. Switch on your machine then press For hygienic reasons, it is recommended to rinse the coffee system daily or when not used For a longer period (more than 2 days). [. . . ] Fill the tank with mineral water high in calcium ( > 100 mg/L) and make successive steam cycles (5 to 10 cycles) in a container until a continuous jet of steam is obtained. The steam nozzle had already worked: · Check that the hole in the tip is not clogged. See section above: "The steam nozzle of your machine appears to be partially or completely clogged". If after performing the above steps, the steam Nozzle still doesn't work, please contact KRUPS Consumer Service. [. . . ]