User manual KRUPS ESSENTIAL EA8161

[. . . ] This product may differ from the photos This product may differ from the photos Dear Customer, Thank you for having purchased this Krups Espresseria Automatic. We are sure you will enjoy both the quality of the coffee it makes and how easy it is to use. Whether you want a short, strong shot of a ristretto, a good espresso, a larger and milder lungo, or a creamy cappuccino, your automatic coffee / espresso machine has been designed so you can enjoy the same quality at home as at the bistro, whatever the time of day and right through the week. Thanks to its Thermoblock System, its 15 bar pump and because it uses real coffee beans that are ground just before the coffee is made, your Espresseria Automatic will give you a drink containing maximum aroma, with a fine creamy golden brown top produced by the natural oils contained in coffee beans. [. . . ] After the steam function has been used, the nozzle will be hot, and we recommend that you wait for a few moments before handling it. Press the "steam" key and follow the instructions on the screen. To remove any remaining milk from the steam nozzle, place a container under the nozzle and press the "steam" key . Let the hot water escape for at least 10 seconds and then again press the "steam" key to stop water. Wash it using a brush with water and a little non-abrasive washing up liquid. Before re-fitting, make certain that the air inlet holes are not clogged by milk residues. The maximum duration for production of steam per cycle is limited to 2 minutes. setting up the Auto-cappuccino XS 6000 (sold separately) This auto-cappuccino accessory makes it easier to make a cappuccino or a caffe latte. Select the cappuccino or caffe latte position on the special nozzle - Fig. 27 and place a cup or a glass underneath the auto-cappuccino nozzle - Fig. Place your cup under the coffee outlets and start a coffee / espresso cycle - Fig. The tube must not be twisted to ensure that the button is held in the correct position. To prevent milk from drying on the auto-cappuccino accessory, it must be cleaned thoroughly after use. It is recommend that you wash it immediately by carrying out a cycle with steam and the accessory pot filled with water in order to clean the inside of the nozzle. To do so, you can use liquid cleaner XS4000, available as an accessory. To benefit from the guarantee conditions, it is essential to perform the appliance cleaning or a scale removal cycle when informed to do so. You can continue to use the appliance, but you are advised to perform the program as soon as possible. Emptying the used coffee collector and the drip collector tray if the above message appears- Fig. 30, remove, empty and clean the drip tray (the drip tray may contain coffee grains). As soon as you remove the coffee grounds collector, you will have to empty it completely to avoid any overflow. The warning message will remain displayed if the coffee grounds collector is not slotted in fully or not fitted correctly. You cannot make espresso or coffee while the warning message is displayed. [. . . ] Try changing the type of milk if this does not work (UHT or pasteurised). Check that the two ends of the small stainless steel tube are fitted correctly into the flexible part of the steam nozzle. Check that the flexible tube is not twisted and that it is correctly fitted into the accessory to avoid any air being sucked in. After switching off your appliance and leaving it to cool, unblock the outlet of the Auto-Cappuccino accessory. [. . . ]