User manual KRUPS EA 8161

[. . . ] CAUTION: Please read the safety instructions before using your appliance The appliance is ready to be used. Check coffee grounds collector is not missing or incorrectly positioned. One beep when pressing ON/OFF: turning on the power on the activated appliance. One beep every ten seconds: the appliance is awaiting instructions from the user. [. . . ] 6 quickly to start a coffee circuit rinsing cycle, Rinsing out the steam circuit: Place a container under the steam nozzle and press the which will automatically stop after around 300 ml. Button for 3 seconds to start a steam circuit rinsing cycle, Appliance cleaning program, 3 times a year (total duration: about 13 minutes) For hygienic reasons and to preserve all best coffee flavor we recommend you to clean the coffee system when the machine asks you to, about 3 times a year. To perform this cleaning you will need: - 1 KRUPS cleaning tablet - 1 container of minimum 600ml several flows will follow one another When to carry out this program?When it is necessary to run a cleaning program, the appliance alerts you by flashing the CLEAN indicator light. This program can only be accessed when the appliance requests it (approximately every 300 brews of coffee or espresso). To comply with the warranty conditions, it is essential to perform the cleaning cycle when the appliance alerts you. Follow the order of operations carefully Use only KRUPS cleaning tablets (available on our KRUPS. The CLEAN indicator becomes solid and the and Remove, empty, clean and replace the coffee grounds collector Fig 21-22 The indicator light go off. Insert the KRUPS XS3000 cleaning tablet into the cleaning chute Fig 26. Several water flows follow one another in several phases without any necessary intervention. They allow the device to be rinsed and the cleaning residue to be removed. The cleaning cycle is finished when the light stays on and the CLEAN light goes out, empty the drip tray. We cannot be held responsible for any damage that may result from the use of tablets from other brands. Make certain to protect your work surface during cleaning and scale removal cycles, especially if it is made of marble, stone or wood. The `CALC' light becomes constant and the indicator lights and flash. Empty the tank and refill it with warm water up to the line `CALC' - Fig. At the end of this phase, the sound signal beeps every 10 seconds and the indicator light ' flashes. At the end of this phase, the sound signal beeps every 10 seconds Remove and empty your used water container and put it back in place. When the descaling cycle is finished, the indicator light `CALC' goes out. If there is not enough water in the water tank, you will be warned by the light. Add the appropriate amount of water to the tank and scale removal will continue automatically. If you unplug the appliance during cleaning, press the button, or there is an electrical power cut, the cleaning program will start again from the beginning. [. . . ] At the beginning or end of making a drink, the steam nozzle may drip slightly. Check that the coffee bean container has coffee in it and that it is dispensing correctly. The appliance has restarted automatically and is ready for a new cycle. The appliance only requests to be cleaned once it has made several types of coffee. [. . . ]