User manual KORG SV1

[. . . ] Assembly Instructions Instructions de Montage Zusammenbau des Ständers Procedura di Assemblaggio Keyboard Stand E F G I ST-SV1 J 3 Precautions before assembly Before you begin to assemble the stand, please keep the following in mind: • • • • To assemble the stand, two people are needed. When placing the piano on the stand, be careful not to pinch your hands. Be sure to follow the steps in order, and make sure that the parts are assembled in the correct orientation and position. [. . . ] Once the movable part of the leg is correctly positioned, tighten the screw (d) to lock it. Note: The first position (the lower hole) corresponds to the standard height of a grand piano’s keyboard. The fourth position (the half-moon symbol) is used to play while standing up. Please repeat the same procedure for all the other legs, being careful to position them all at the same height. Lift the bracket (a), and insert it into the corresponding hole (e”) in the leg (c”). Warning: Be careful not to pinch your fingers between the leg and the bracket!Turn the stand (B) upside down, so that the feet are laying on the floor. Place the concave side of the bracket (f) toward you – the KORG logo (g) must be visible on your side. Adjust the height of the feet (h), by turning them by hand and leveling the stand on each side, even if it is not completely even. We suggest you prevent the nut (i) from turning with the help of the supplied 11/16” wrench (j). After adjusting each of the feet, make sure that the nut (i) touches the leg’s border. Using two people, lift the piano (A), and attach it to the ST-SV1 stand (B). While one person prevents the piano from falling down, the other should make the small rubber foot (k) under the piano line-up to the concave side of the bracket (f), and the screw (l) under the piano with the space left on the side of the convex side of the bracket (m). Align the holes (n) under the piano to match the screws (o) of the stand. [. . . ] If you need to packup the piano, reverse the assembly order by which the piano was attached to the stand and the stand was assembled. For improved protection, we suggest you also replace the protective sheet and the holders (x) securing the brackets (see step 1). Après le montage, les vis et les boulons du support peuvent se desserrer avec le temps et rendre le support instable. [. . . ]