User manual KORG SP170S

[. . . ] Maniement Entretien Keep this manual After reading this manual, please keep it for later reference. If liquid gets into the equipment, it could cause a breakdown, fire, or electrical shock. If something does slip into the equipment, unplug the AC adapter from the wall outlet. Then contact your nearest Korg dealer or the store where the equipment was purchased. [. . . ] Connecting audio components Figure 4 You can use the PHONES jacks as line-out jacks to connect powered speakers or audio components to the keyboard. For such connections, use commercially-available cables that are appropriate for the components that you’re using. Before connecting audio components, make sure that you turn off the power to the unit and the audio components. Using the music stand • Insert the legs of the supplied music stand into the dedicated groove that’s located in the middle of the top panel. (Figure 4) 1 Playing Different Sounds The SP-170S features 10 preset sounds. Pressing the SOUND button repeatedly will change the sound in the following sequence. Whenever you turn on the unit, the default preset sound (Piano 1) will be recalled. Organ: Strings: You can also change the sound by pressing one of the keys ranging from C7 to A7 while simultaneously pressing and holding down the PIANO PLAY and SOUND buttons. ) Using Other Functions The SP-170S allows you to play back the songs or adjust various functions by pressing a specific key while also pressing and holding down the PIANO PLAY and SOUND buttons. Please refer to the “MIDI” section on the next page for more information on MIDI channels and program change messages. While pressing and holding down the PIANO PLAY and SOUND buttons, do not play the keyboard. For information on the functions that are assigned to the keys, please refer to “Key Functions” on pages 2 and 3. About the confirmation sound When you press a key to adjust settings for a function, you will hear the confirmation sound. To turn this sound off, simultaneously press and hold down the PIANO PLAY and SOUND buttons and press the A# 0 key. To turn on the confirmation sound, repeat the previous procedure but press B0 instead of A# 0. The confirmation sound is set to On by default (when you turn the unit on). Heavy G ENA ENA G A A B C C D D E F DIS G3 A3 2 1 3 4 5 6 7 Key Touch Confirmation sound On/Off B0 C1[24]* C2[36]* D2 E2 F2 Transpose (F 2–F3) C3[48]* 8 MIDI C4[60]* 2 Enabling/Disabling Enabling/Disabling Program Change Control Change transmission transmission A3 B3 Playing Back Songs The SP-170S features 10 songs that use 10 preset sounds. Key Touch Control function While pressing and holding down the PIANO PLAY and SOUND buttons, press one of the keys ranging from C6 to A6 (on the right side of the keyboard). The song assigned to the key that you pressed (as shown below) will start playing. Playback starts from the selected song, then continues and repeats all songs in ascending order until you stop playback. to stop playback , press the PIANO PLAY and SOUND buttons simultaneously. During playback of a song, you can switch the sound using the PIANO PLAY and SOUND buttons while playing the keyboard. [. . . ] When you select a preset sound on the SP-170S (see “Playing Different Sounds” on page 2), it transmits a MIDI Program Change number (PC#) as shown in the table below. To disable this transmission (DIS), press and hold down the PIANO PLAY and SOUND buttons simultaneously, and then press the G# 3 key. To enable this transmission (ENA), repeat the previous procedure but press the A3 key instead. To disable this transmission (DIS), press and hold down the PIANO PLAY and SOUND buttons simultaneously, and then press the A# 3 key. [. . . ]