User manual KORG PX3B

[. . . ] Precautions Location Using the unit in the following locations can result in a malfunction. € In direct sunlight • Locations of extreme temperature or humidity • Excessively dusty or dirty locations • Locations of excessive vibration Power supply Please connect the designated AC adaptor to an AC outlet of the correct voltage. Do not connect it to an AC outlet of voltage other than that for which your unit is intended. Handling To avoid breakage, do not apply excessive force to the switches or controls. [. . . ] Tune the string of your bass so that the indicator above the center mark is lit. The tuner (bypass/mute) will be turned off when you press either the BYPASS· tUNE button or change the program. Calibration (frequency of the standard A=440 pitch) You can use the Value dial to adjust calibration in the range of A = 438 Hz–445 Hz. The calibration setting you make will be valid until the power is turned off. Once the power is turned off, calibration will be reset to A = 440 Hz. HBB (Hyper Bass Boost) This function boosts the low-frequency range that is often insufficient when using small headphones. This function is also effective when the PANDRA PX3B is connected to a bass amp or mixer. The HBB on/off setting is remembered even when the power is turned off. Specifying the function of the Value Dial You can specify the function that the Value dial will perform in Play mode. If you turn off the power or select another program without performing "9) WRITE, " the program will return to its original settings. The LCD will indicate "EQ L, " and the EQ icon will light to indicate that you are in Equalizer mode. If you perform this procedure for a program whose equalizer is OFF, the equalizer will forcibly be turned ON. As necessary, press the L (BYPASS/ ], M (PHRASE TRAINER [ ]), TUNE [ H (EDIT√ [ ]), Pr (RHYTHM/AUX EFFECT), Tr (EDIT®[HOLD]) buttons to display the values in 24 Rhythm Trainer mode In Play mode (except during Mute/Bypass or Key Lock), AUX Effect mode, or Phrase Trainer mode, you can press the RHYTHM/AUX EFFECT button once to enter Rhythm Trainer mode. When you enter this mode, the selected rhythm will start, and the Rhythm Trainer mode icon will blink. Use the EDIT√ /® buttons to select a parameter, and use the value dial to set the value of each parameter. Level display • Value dial: Set the level of the rhythm pattern rhythm pattern • Value dial: Set the rhythm pattern 25 AUX Effect mode In this mode, the sound of a CD or other audio source connected to the AUX jack can be pitch-shifted by using the Key Transpose (K-TRN), or the lowfrequency range can be eliminated by using the Bass Cancel (B-CAN) function. In Rhythm Trainer mode, press the RHYTHM/AUX EFFECT button once to enter AUX Effect mode. b-CAN display OFF ON K-TRN display OFF • EDIT √ /® buttons: Switch between K-TRN and B-CAN displays • BYPASS· TUNE button: Switch K-TRN or B-CAN on/off • Value dial: Set the amount of transposition • +/– buttons: Select programs The key transpose setting can be adjusted in the range of +/–1 octave. The key can be raised or lowered in 10 cent steps for the first three semitones, and in semitone steps (100 cents) thereafter. ON 100 cent unit display 26 When K-TRN or B-CAN is turned on, the output will be mono. When you enter this mode, the MOD (modulation) and D/R (delay/reverb)effects will automatically be turned off. For some input sources (mono recordings, or when special effects were used during recording), B-CAN may not produce the desired effect. [. . . ] If you press the BYPASS· TUNE button, the factory-set programs will be re-loaded into the user program area. The display will indicate “LOAD”, “VERI”, “COMPL” for a short time, and then the power-on screen will appear. Be aware that if you reload the factory programs, all user programs will be rewritten. 34 Troubleshooting If the PANDORA PX3B does not operate as you expect, please check the following points first. [. . . ]