User manual KORG PITCHJACK

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. [. . . ] Keeping foreign matter out of your equipment Never set any container with liquid in it near this equipment. If liquid gets into the equipment, it could cause a breakdown, fire, or electrical shock. IMPORTANT NOTICE TO CONSUMERS This product has been manufactured according to strict specifications and voltage requirements that are applicable in the country in which it is intended that this product should be used. If you have purchased this product via the internet, through mail order, and/or via a telephone sale, you must verify that this product is intended to be used in the country in which you reside. WARNING: Use of this product in any country other than that for which it is intended could be dangerous and could invalidate the manufacturer’s or distributor’s warranty. Please also retain your receipt as proof of purchase otherwise your product may be disqualified from the manufacturer’s or distributor’s warranty. CALIFORNIA USA ONLY This Perchlorate warning applies only to primary CR (Manganese Dioxide) Lithium coin cells sold or distributed ONLY in California USA. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 8 6 Gently press the battery cover on the back of the GB-1 with the side of your thumb and turn the cover counterclockwise to remove it. Install the battery so that the positive (+) side of the battery is facing up. As the battery runs down during operation, the string name indicator LED will blink and the LED meter will not operate smoothly, resulting in inaccurate tuning. You must remove the GB-1 from the instrument and turn off the power before replacing the battery. The included battery is for verification of operation, and may have a shorter lifespan than usual. You should also remove the battery if you won’t be using the tuner for an extended period of time. Insert the 1/4” connector into your guitar/bass output jack and adjust the position of your instrument so that the display can easily be viewed. Always hold the part just above the input plug as shown in the diagram when you install or remove the GB-1 from your instrument. If you hold the GB-1’s body and insert it into the input plug, the hinge section may become damaged. Set the [GUITAR/BASS] selector switch according to the connected instrument. [. . . ] Using the Flashlight Press the [FLAT/LIGHT] switch while the [POWER] switch is set to STANDBY and the flashlight LED will stay on while the switch is held. If the [POWER] switch is ON, the tuner may automatically shut off when not in use. If this occurs, the flashlight will not operate even if you press the [FLAT/LIGHT] switch. [. . . ]